Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
If the permanent press load is wrinkled, add a wet towel and operate the dryer for an additional 10 minutes with heat and cool down, remove load immediately. LINT FILTER The lint filter is located at the front of the dryer in the lower part of the door opening. See illustration below. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. A clean lint filter insures efficient drying. The filter can be taken out to remove lint. TO REMOVE LINT: Wipe across the filter with damp fingers. TO REMOVE LINT FILTER: Lift filter up and out of door opening. See illustration below. Filter may be washed if any residue is noticed on it. TO REPLACE FILTER: Place filter in door recess and push in firmly. Be sure to replace the filter with the words FRONT facing the front of the dryer. CAUTION - THE LINT FILTER MUST BE IN PLACE IN THE DOOR OPENING WHEN USING DRYER OR LOADING AND UNLOADING DRYER. If the filter is not in place, clothing could fall into the front air duct and get into the exhaust system and cause damage to the motor. EXHAUST SYSTEM We recommend the dryer be exhausted to the outside atmosphere to assure maximum drying efficiency. The exhaust duct should be cleaned periodically to remove any obstructions. Check occasionally to make sure the flapper on the outside weather hood moves freely, is not pushed in and that nothing has been shoved against it. Check too that the flapper is not standing open. -9-...
Эта инструкция также подходит к моделям:Сушильные машины - LE1100 (989.41 kb)
Сушильные машины - LED250 (989.41 kb)
Сушильные машины - LG1101 (989.41 kb)