Оценок - 3, средний балл: 4.3 ( )

Производитель: AEG Размер: 475.29 kb Название файла: 944111en.pdf Язык инструкции:

4.5 hours after the beginning of the drying process: - END (EINDE) display is illuminated -acoustic signal sounds - discontinuation of the drying process -Program run display is flashing Foreign bodies, e. g. animal hairs, can block the inlet nozzle as well as the valve on the end of the container Too dry or too little laundry filled-in for the selected program SPECIAL CARE (LAGE TEMPERATUUR) button pressed and too much laundry filled-in With the container pulled out, switch on the appliance momentarily. The blockage can be removed from the container shaft or the hair cleaned out of the valve Select time program or higher drying stage (e.g. EXTRA DRY (EXTRADROOG) instead of VERY DRY (INTENSIEFDROOG)) Check the program selection: SPECIAL CARE (LAGE TEMPERATUUR) button appropriate only for laundry amounts up to 2.5kg Too much laundry Reduce the amount of filled-in laundry filled-in Laundry too damp Pre-dry the laundry more thoroughly If you do not find the required information in this manual to remedy a disturbance, please call the customer service. Something not working? Replace the interior light 0 A replacement bulb can be purchased through your local AEG Service Force Centre (Part No: 647072580). 1 Warning! Never use standard light bulbs in your Lavatherm. 0 Isolate the appliance from the mains supply. 0 Screw-off the bulb cover. (The bulb is located at the top behind the door; see Front view). 0 Replace the defective bulb. 0 Screw-on the bulb cover. 1 Warning! For safety reasons the bulb cover must be screwed-on. The dryer must not be operated, without the cover in place. Door Reversal Instructions 30 Door Reversal Instructions The door opening direction can be changed if required. 1 Warning! Before reversing the door, isolate the appliance from the mains supply. Proceed as follows to reverse the door opening direction: 0 Un-screw the screws A on the front panel of the appliance. 0 Take-off the door by displacing it horizontally. 0 Un-screw the screws B on the inside of the door and take-off the hinges C. 0 Unscrew and take-off the locking block D. 0 Release the coverplates E, F and G with a thin screwdriver by pressing on the latching device, displace them to the side. Take them out and insert them again on the opposite side. 0 Screw-on the hinges C and the locking block D on the opposite side of the door. 0 Screw-off the door catch H and remove it. F A C B E D F E H A C B J G Door Reversal Instructions 0 Take-out the latched catch covering J. 0 Connect the door catch H and the catch covering J on the respective opposite side to the plug and screw-down or latch into position. 0 Push the door with the hinges into the breakouts provided for them in the front panel of the appliance and firmly attach it with the screws. 1 Warning! The appliance is safe again for operation only when all plastic parts have been mounted. Technical data Technical data Height x Width x Depth 85x60x60cm Depth with the door open 117cm Height adjustable from 1.0/–0.4cm Empty weight approx. 46 kg Load (depending on the program) max. 5kg (Different loads in some countries are due to different measuring methods) Power consumption in acc. with IEC 1121 s.e. 3.5 kWh (5 kg Cotton, spun at 800 revolutions per minute, program COTTON CUPBOARD DRY) Area of use Household Permissible ambient temperature +5°C up to +35°C ; This appliance complies with the following EC directives: – 73/23/EEC of 19/2/1973 ’Low voltage directive’ – 89/336/EEC of 3/5/1989 ’EMC directive’ including the Modification directive 92/31/EEC Installation and electrical connection Please refer to the type plate for specifications about the power supply. The nominal voltage stated on the type plate and type of current must be identical with the nominal voltage and type of current at the point of installation. Also refer to the type plate for the fuse required. Information for the electrician When connecting the appliance without a plug, care must be taken that this is done correctly. Please follow the relevant information in the section on installing and connecting the appliance. For appliances with variable voltage settings, the switch-over diagram can be found on the cover of the connection box at the back of the appliance. Special accessories Special accessories You can obtain the following special accessories from your retailer. Drainage kit With this kit (E-No. 916 019 000) you can lead the condensate directly into a drain (sink, siphon, drain grating) with a maximum feed height of 1m above the floor on which the dryer is standing (3m Length). Emptying he condensate container is then no longer necessary. You can then ignore the EMPTY WATER (RESERVOIR) indicator at the end of each program. However, the condensate container must be inserted correctly in the operator control mask. Stacking kit With these kits you can combine your laundry dryer with any LAVAMAT automatic washing machine to a washing and drying column. The appliances are stacked in space-economising manner ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: