Оценок - 4, средний балл: 3.8 ( )

Производитель: AEG Размер: 2.66 mb Название файла: 917040EN.pdf Язык инструкции:

CLEANING THE HEAT EXCHANGER FILTERS If the applicable indicator (clean the heat exchanger filters) is on, the filters must be cleaned. ENGLISH 21 To clean the filters: 1. Open the loading door. 2. Move the release button on the bottom of the door opening and open the heat exchanger door. 3. Turn the blockage to unlock the heat exchanger cover. 4. Lower the heat exchanger filters cover. 5. Lift the primary filter. Hold the heat exchanger filter and pull it out from the bottom compartment. 6. Push the hook to open the filter. 7. Use a moist hand to clean the filter. If necessary clean the filter with warm water using a brush. Close the filter. ENGLISH 23 8. Clean the small filter from the base 9. If necessary, one time for each 6 months, remove the fluff from the heat exchanger compartment. You can use a vacuum cleaner. 10. Put the small filter and heat exchanger filter back. 11. Close the heat exchanger cover. 12. Lock the blockage until it snaps. 13. Close the heat exchanger filters cover. 14. Close the heat exchanger door. 15. Put the primary filter. CAUTION! Do not operate the tumble dryer when the heat exchanger filters are blocked with fluff. This could cause the damage to the tumble dryer. This also increases energy consumption. Do not use sharp objects to clean the heat exchanger compartment. Do not operate the tumble dryer without the filters. CLEANING THE DRUM WARNING! Disconnect the appliance before you clean it. Use a standard neutral soap detergent to clean the inner surface of the drum and drum ribs. Dry the cleaned surfaces with a soft cloth. CAUTION! Do not use abrasive materials or steel wool to clean the drum. CLEANING THE CONTROL PANEL AND HOUSING Use a standard neutral soap detergent to clean the control panel and housing. Use a moist cloth to clean. Dry the cleaned surfaces with a soft cloth. ENGLISH 25 CAUTION! Do not use furniture cleaning agents or cleaning agents which can cause corrosion to clean the appliance. TROUBLE SHOOTER AND SERVICE TROUBLESHOOTING Problem1) Possible cause Remedy The tumble dryer is not connected to mains supply. Connect in at mains socket. Check fuse in fuse box (domestic installation). The tumble dryer does not operate. The loading door is opened. The On/Off button was not pushed. The Start/Pause button was not pushed. Close the loading door. Push the On/Off button. Push the Start/Pause button. The appliance is in the standby mode. Push the On/Off button. Incorrect programme selection. Do the selection of the applicable programme. 2) The filter is clogged. Clean the filter. 3) The Dry Plus function was in minimum mode. Change the Dry Plus function to the moderate or maximum mode. Unsatisfactory drying results. The condenser is clogged. Too high volume of the load. Clean the condenser. 3) Obey the maximum load volume. The airflow grill is clogged. Clean the airflow grill in the bottom of the appliance. Dirt on the inner surface of the drum. Clean the inner surface of the drum. Too high water hardness. Set applicable water hardness4). The door does not close. The filter not locked in the position. The laundry is locked between the door and the seal. Put the filter in the correct position. Put the load correctly in the drum. Err (Error) You try to change the programme or the function after the start of the cycle. Turn the tumble dryer off and on. Make the new selection. on the display. The function you try to activate Turn the tumble dryer off and is not applicable with the selec on. Make the new selection. ted programme. No drum Contact the service centre to re- Defective drum light. place the drum light. light 5) ENGLISH 27 Problem1) Possible cause Remedy Abnormally elapsing time on the display.) The time to end is calculated on the basis of the volume and dampness of the laundry. The automatic procedure — this is not the appliance malfunction. Programme inactive. The water container is full. Drain the water container3) , push the Start/Pause button. Drying cycle too short. Too small laundry volume. Do the selection of time programme. The time value must be related to the load. To dry one item or small quantities of the laundry we recommend to use short times. The laundry is too dry. Do the selection of time programme or higher drying level (e.g. Extra Dry ) The filter is clogged. Clean the filter. Too high volume of the load. Obey the maximum load volume. Drying cycle too long 6) The laundry not spun sufficiently. Spin correctly the laundry. Very high room temperature this is not the appliance malfunction. If possible, lower the room temperature. 1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the new programme. Push the Start/Pause button. Does not operate? contact the service centre and give the error code. 2) follow the programme description — see PROGRAMMES chapter 3) see CARE AND CLEANING chapter 4) see section WATER HARDNESS in HINTS AND TIPS chapter 5) Only the tumble dryers with drum lig...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: