Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
• Remove the laundry from the dryer. • Turn the appliance off by turning the jog selector (A) to the position “0”. • Clean the lint filter (see chapter on Cleaning and Maintenance). • Close the dryer door. • Empty the water container (this applies for condensation dryers only - see Cleaning and Maintenance) and replace it back to its slot. • Pull the power lead from the socket, disconnecting the appliance from the mains. 129316 12 Interruptions • By the user After drying be careful when extracting laundry from the appliance, as it may be hot! Suspending the operation by pressing the START/PAUSE button. In case you press the START/PAUSE button (D) during the drying procedure, the drying program is suspended, and with the next press of the same button the program is resumed where it had been interrupted. Changing the program or the functions If you wish to change the drying time during the drying procedure, move button (A) to the position “0” (for about 1 second), set new drying time and press the START/PAUSE button (D). The same procedure applies if you wish to change settings (selection of functions by means of buttons). Door opened If the door is opened during the drying process this will pause the operation (the (E) LED flashes intermittently). The drying process is resumed by closing the door and pressing the START/PAUSE button (D) from the point where it had been interrupted. • Power failure If a power failure occurs during the operation of the dryer, this requires that drying time is reset again, and all extra functions are reselected (LED E flashes as at the commencement of the program). 129316 13 • Water container is full (condenser appliance only) When the container is full, signal lamps (E) and (F) are flashing. The drying program is interrupted. When the container is emptied, press the START/PAUSE button (D) to reactivate the drying program. 129316 14 • Drying is economically most effective if you dry the recommended quantity of laundry per one charge (see Program Chart). • Do not dry the laundry made of especially sensitive fibers (wool, silk), which may shrink or lose shape. • It is not necessary to use a fabric conditioner when washing the laundry, since drying makes it soft and tender. • Drying time is much shorter and consequently the energy consumption lower if laundry is well spun prior tumble dring (minimum 1000 spin RPM). • By selecting the most suitable drying program, you will avoid over-drying and deffi cult ironing. • By cleaning the filter on regular basis drying time is shorter and consumes less energy. Tips for drying and for economic useof the dryer 15 129316 129316 16 Cleaning and maintenance Cleaning the filter Cleaning the condensation dryer • After every drying clean the filter, located in the inner part of the door. • Lift the filter lid (Fig.). • Pull your fingers over the filter to remove fibers and threads lining. Replace the fi lter cover. • If necessary, also clean the filter housing and door sealing. Cleaning of the filter on the lower side of the door opening (only with some models) Before removing clothes from the drum, clean the filter on the lower side of the door opening with a damp cloth or wet hand. If the filter is clogged in such way that it needs washing, pull it out from its bed (Fig.), wash it under hot water and dry. Be sure that the replaced filter snaps safely to its position, and only then close the fi lter lid. If the filter is not regularly cleaned, the airflow is obstructed, which causes longer drying time and danger of overheating. Empty the container and occasionally clean the water condensation device. Emptying the water containere Empty the container after every drying procedure: pull the container out, pull out the draining nozzle, pour out the water and replace the container. Water from condenser tank is not drinkable! If filtered it may be used for ironing. Cleaning of evacuation drier Cleaning the water condensation device Strictly switch the appliance off prior cleaning (unplug the power cord from the wall socket, or turn the selector jog to the position “0”). • Clean the casing and drum interior with soft cloth and mild detergent. • Periodically clean (vacuum) the interior of air evacuation opening and evacuation tube. Water condensation device should be cleaned three to four times a year, in case of very frequent use even more often. During cleaning a certain amount of water may drip out so it is good to put an absorbing cloth below the opening. • Open the exterior lid of the condenser by grabbing the handle on the lower left part of the appliance housing and pull it downwards. • Remove the interior lid by first turning the lever vertically down, then tilt the lid towards yourself and remove it. • Turn the lock on the condenser upwards and pull the condenser out by pulling the lever. • Clean the device from both sides with lukewarm water and drain it well. • Before replacing it into its slot, clean the air channel in which the device is mou...