Оценок - 4, средний балл: 4 ( )

Производитель: Alliance Laundry Systems Размер: 528.08 kb Название файла: a04f6500-c24b-4c95-927d-0d4146bef583.pdf Язык инструкции:

Static: • Caused by over drying. Adjust for shorter drying time. • Mixed with synthetic fabric. Sort and separate different fabrics. • Use a fabric softener. 14 English ELECTRICAL REQUIREMENTS Electrical Shock Hazard Plug into a grounded 4 prong outlet. Failure to do so can result in death or electrical shock. Warning It is your responsibility • To connect a qualified electrical installer. • To be sure that the electrical connection is adequate and in conformance with CAN1-B149 (.1 or .2) installation codes and/or local codes. • A 4 wire, single phase, 115/230-volt, 60-Hz., AC-only electrical supply is required on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit. • This dryer is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle. The cord is 5 ft (1.52 m) in length. Be sure wall receptacle is within reach of dryer’s final location. 4-wire receptacle 14-30R If using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement. For further infromation, please reference the service numbers located in the “Assistance or Service” section of this manual. 15 English Replacement Power Supply Cord must be: • UL Listed or CSA Interantional Certified • Marked for use with clothes dryers • Rated 115/230 volt minimum • 30 amp • Type SRD or SRDT • 4 Conductors • At least 5 ft (1.52 m) long. Grounding Instructions • For a grounded, cord-connected dryer: This dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric current. This dryer is equipped with a cord having an equipment-grounding conductor and a grounging plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Warning: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. Do not modify the plug provided with the dryer: if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Save These Instructions 16 English INSTALLATION INSTRUCTIONS • Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom of the dryer. Unpacking Your Dryer 1. Remove all packaging material. This includes the foam base and all adhesive tape holding the dryer accessories inside and outside. 2. Inspect and remove any remains of packaging, tape or printed materials before using the dryer. Tools and Materials Required • Phillips head and flathead screwdrivers • Channel-lock adjustable pliers • 1/2 inch open end wrench • Carpenter’s level • Measuring tape (12ft. min.) • Duct tape • Rigid or flexible metal 4 inch (10.2 cm) duct • Vent hood 17 English EXHAUST SYSTEM CONNECTIONS Requirements and Instructions WARNING The ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: