Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
You must set suitable water level by yourself. 11 Attention Attention Even there's no water in the tub, the spinning will start after a certain period. Do not use soak process for woolen laundries. Wash the laundries that are prone to lose colors separately from other laundries. The pulsator will not rotate unless the water is filled to selected water level. Selection method of the procedure programs Times of pushing Contents(tthe nixie tube indicates Selected program Applicable procedure the"select"button the programs about to run) 0 Normal wash Wash (bb) Rinse(cc) Spin(dd) Large, thick or heavily soiled STANDARD Soak (AA) Wash (bb) 1 JEANS Rinse (CC) Spin (dd) laundry The laundry needn't spin to 2 GENTLE Wash (bb) Rinse(cc) Spin(dd) avoid wrinkles Wash (bb) Rinse(cc) Spin(dd) 3 QUICK WASH For load below 1 kg Repeat using the washing Wash (bb) 4 WASH liquid When the laundries need only SPIN 5 spinning after manual Spin(dd) washing (first drain then spin) If you push the " PROGRAM/ RESERVATION " button for 6 times, it will resume the original mode, and it will circulate like that. If you select the"QUICK WASH" program, you have to set the full procedure of wash, rinse and spin. The procedure can not be selected. 12 3 Press the "WATER LEVEL" button to select suitable water level WATER LEVEL After switching on the power, press the button "WATER LEVEL" to select a water level according to the load. Please refer to the button " Water level" on page 10. Page 10 4 Push the " PROGRAM/RESERVATION " button to select suitable reserve program PROGRAM RESERVATION After switching on, the washing machine reserved wash program will be automatically set inactive. If you desire a wash cycle to end at a reserved time, you can press the "PROGRAM/RESERVATION"button over 2 seconds to set a reserved wash program. Refer to The button of "PROGRAM/RESERVATION" on page 10. Confirm the reserve program Page 10 When "Reservation" becomes active, the nixie tube displays the time to the end of the reserved wash cycle, and the indicator turns on.During reserve procedure,push the "Reservation" button to display the reserve mode. To change the running program or cancel the reservation, you should cut off the supply and reselect. the washing will finish about 18 hours later 5 Press the "start/pause" button START PAUSE Close the top lid Finish washing During running , if the top cover is opened, the washing machine will stop running and alarm. The washing machine cuts off the power supply automatically when wash cycle ends. 13 Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean When washing, lint filter must be used After using, please clean it in time. Lint filter: 1.Pull upward to detach 2.Clean the lint Put it in water and clean while it is still wet. (See to Figure 1). 3.Press downward to assemble. Figure 1 Figure 2 If the cabinet is dirty, wipe it with wet cloth Do not flush it directly with water. Wipe it with neutral detergent. Do not wipe it with thinner, petrol, alcohol etc. ThinnerAlcohol Petrol The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it Dismantle Install 1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose). 2.Do not store water in the washing machine for a long period. Drain the water completely after each using. 3.Be sure to pull off the power plug before maintenance. 4.Hang up the power cord and drain hose. 5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (about 1 hour), then close the top lid. 14 Trouble shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena The reason How to settle The top lid is not closed. Is the drain hose put down? Is the drain hose blocked by foreign material? Are the laundries put slantingly? Are the laundries slanting in spinning? Is the machine slanting? Is the machine slanting? The water tap is not open The water inlet valve is blocked Is there power failure? Is the power plug loose? Is the jointer screw of the water inlet hose is loose or twisted awry? The water faucet leaks. There's abnormal sound inside the machine. The machine does not act. Close the top lid. Put down the drain hose. Open and close the top lid once. Clean the foreign material. Open and close the top lid once. Re-order the laundries. Close the top lid. Level the machine in right position. Open and close the top lid once. Open the water tap. Push...
Эта инструкция также подходит к моделям:Стиральные машины - HWM50-10B (835.47 kb)