Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
.. Flashing: The machine detected an imbalance in the drum that cannot be adjusted. The maximum spin speed cannot be reached in order to protect the machine. The washing solution will not be removed completely after spinning, and the subsequent drying programme is automatically stopped. If the drying cycle stops and ...... flashes on the display, the cooling programme will keep running automatically until ...... disappears and the door can be opened. - Wash or dry small and large items of laundry together. After the auto drying cycle, the symbols and ...... are displayed alternately, suggesting that the drying result may not be satisfactory. – : the amount of laundry is too much. : the amount of laundry is too little. Other displays Switch off the appliance, wait 5 seconds and switch it back on. If the display appears again, call customer service. Safety instructions – Read and follow the operating instructions as well as the installation and maintenance instructions and all other information enclosed with the washer dryer. – Retain documents for subsequent use. Risk of electric shock – Never pull out the mains plug by pulling on the power cord. – Never insert/pull out the mains plug with wet hands. Risk of death For worn-out appliances: – Pull out the mains plug. – Sever the power cord and discard together with the plug. – Destroy the lock on the washer dryer door. This will prevent children from locking themselves in and putting their lives at risk. Risk of suffocation – Keep packaging, plastic film and packaging parts out of the reach of children. Risk of poisoning – Keep detergents and care products out of the reach of children. Risk of explosion – Items of laundry pretreated with cleaning agents containing solvents, e.g. stain remover/cleaning solvents may lead to an explosion after being loaded into the washer dryer. Rinse items of laundry thoroughly by hand beforehand. Risk of injury – Washer dryer door may become very hot. – Take care when draining hot detergent solution. – Do not climb onto the washer dryer. – Do not lean on the washer dryer door when it is open. – Do not touch the drum in case it is still spinning. – Ensure that the pump cap is screwed on while the machine is running to prevent water from leaking out and coming into contact with moving pump parts. – If a drying programme was interrupted, the washer dryer and the laundry may be very hot, select Trocknen .. or Schontrocknen ....and set the time dry programme to 15 minutes to allow the laundry to cool down, then remove the laundry. Information on the display 12 What to do if ... .. Water is leaking out. – Fit/refit the drainage hose correctly. – Tighten the screw connection of the supply hose. .. There is no water supply. Detergent is not dispensed. – ....Start/Nachlegen not selected? – Tap not turned on? – Filter blocked? Clean the filter. ..Installation and maintenance instructions, Page 8 – Supply hose kinked or trapped? – There is water in the drum already. .. Washer dryer door cannot be opened. – Safety function active. Programme stopped? ..Page 5 – (no final spin/drain) selected? ..Page 5 – Can be opened by emergency release only. ..Page 13 – Childproof lock activated? Deactivate it ..Page 10 .. Programme does not start. – ....Start/Nachlegen or ....(Finish in) selected? – Washer dryer door closed properly? .. Detergent solution is not drained. – Clean the drain pump. ..Installation and maintenance instructions, Page 8 – Clean the waste pipe and/or drainage hose. .. Water not visible in the drum. – Not a fault - water below the visible area. .. The spin result is not satisfactory. – Wash small and large items of laundry together. – Selected speed too low? ..Page 9 .. The spin cycle performs several times. – This is not a fault – the unbalanced load detection system adjusts the imbalance. .. Compartment .. is not rinsed out completely. – Remove the insert. Clean the detergent drawer and insert it again. ..Installation and maintenance instructions, Page 7 .. Odour forms in the washer dryer. – Run the Flusenspulen cold programme without laundry. – Use standard detergents. .. Foam escapes from the detergent drawer. – Too much detergent used? Mix 1 tablespoon of fabric softener with . litre of water and pour this mixture into compartment II in the detergent drawer. – Reduce the detergent dosage for the next wash cycle. – Use commercially available low foam detergents and care products which are suitable for use in the washer dryer. .. Excessive noise, vibrations and "wandering" during the spin cycle. – Are the appliance's feet fixed? Secure the appliance's feet. ..Installation and maintenance instructions, Page 5 – Have the transport bolts been removed? Remove the transport bolts. ..Installation and maintenance instructions, Page 3 .. Display panel/indicator lights do not function while the appliance is running. – Power failure? – Circuit breaker tripped? Reset the circuit breaker/change the fuse. – If the fault occurs repeatedly, c...