Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
Other displays Switch off the appliance, wait 5 seconds and switch on again. If the same display appears again, call the after-sales service .. page 13. . Risk of electric shock. Disconnect the mains plug. . Risk of explosion. No solvents 11 Information about blockages Detergent solution pump Turn the programme selector to Off, disconnect the mains plug. 1. Open and remove the service flap. 2. Remove the drainage hose from its holder. Remove the sealing cap and allow the solution to drain out. Put the sealing cap back in place. 3. Unscrew the pump cover carefully (residual water). 4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent solution pump must be able to rotate). 5. Put the pump cover back in place and screw it tight. The handle should stand vertically. Insert the drainage hose into its holder. 6. Refit the service flap and close it. To prevent detergent from flowing down the drain unused during the next wash cycle: pour 1 litre of water into compartment II and start the ....Empty programme. Drainage hose at the siphon Turn the programme selector to Off, disconnect the mains plug. 1. Loosen the hose clamp, remove the drainage hose carefully (residual water). 2. Clean the drainage hose and siphon connecting piece. 3. Reattach the drainage hose and secure the connection with the hose clamp. Filter in the water supply Risk of electric shock Do not immerse the AquaStop safety device in water (it contains an electric valve). Reduce the water pressure in the supply hose: 1. Turn off the tap. 2. Select any programme (apart from (....Spin/ ....Empty)). 3. Press .. Start/Reload. Allow the programme to run for approx. 40 seconds. 4. Turn the programme selector to Off. Remove the mains plug from the socket. To clean the filter: 5. Disconnect the hose from the tap. Clean the filter using a small brush. and/or for Standard and Aqua-Secure models: Remove the hose from the back of the appliance, Remove the filter using pliers and clean the filter. 6. Connect the hose and check for leaks. Risk of scalding . Allow the detergent solution to cool down. . Turn off the tap. 12 What to do if ... .. Water is leaking out. . Attach/replace the drainage hose correctly. . Tighten the screw connection of the supply hose. .. No water supply. Detergent not dispensed. . .. Start/Reload not selected? . Tap not turned on? . Filter may be blocked. Clean the filter .. page 11. . Supply hose kinked or trapped? .. Washing machine door cannot be opened. . Safety function active. Programme terminated? .. page 4. . .. (Rinse Hold = without Final spin) selected? .. page 3,4. . Can be opened by emergency release only? .. page 13. .. Programme does not start. . .. Start/Reload or ....(Finished in) time selected? . Washing machine door closed? . Childlock active? Deactivate it .. page 5. .. Detergent solution does not drain. . .. (Rinse Hold) = without Final spin selected? .. page 3,4. . Clean the detergent solution pump .. page 11. . Clean the waste pipe and/or drainage hose. .. Water not visible in the drum. . Not a fault - water below the visible area. .. Unsatisfactory spin result. Laundry wet/too damp. . Not a fault - the unbalanced-load detection system has cancelled the spin cycle because of uneven distribution of the laundry. Distribute small and large items of laundry evenly inside the drum. . .. Easy-iron selected? .. page 5. . Selected speed too low? .. page 5. .. Drum spins gently several times. . Not a fault - unbalanced-load detection system is adjusting the imbalance. .. Residual water in the .... compartment for care products. . Not a fault - the action of the care product is not affected. . Clean the insert if necessary .. page 10. .. Odour formation in the washing machine. . Run the .... Cottons 90 °C programme with no load inserted. Use standard detergent. .. Status display.... flashes. Appliance has detected a detergent overload. . Too much detergent used? Mix 1 tablespoon of fabric softener with . litre water and pour into compartment II (not with outdoor or down fabrics). . Reduce the detergent dosage for the next wash cycle. .. Loud spinning, vibrations and .walking. during the spin cycle. . Appliance feet fixed? Secure the appliance feet .. Installation instructions. . Transport braces removed? Remove the transport braces .. Installation instructions. .. Display panel/indicator lamps do not function during operation. . Power cut? . Circuit breakers tripped? Reset/replace the circuit breakers. . If the fault occurs repeatedly, call the after-sales service. .. Programme sequence longer than usual. . Not a fault - unbalanced-load detection system is adjusting the imbalance by repeatedly redistributing the laundry. . Not a fault - foam detection system active - adds an additional rinse cycle. .. Detergent residues on the laundry. . Occasionally, phosphate-free detergents contain water-insoluble residues. . Use the .. Rinse cycle or brush out the laundry after washing. 13 What to do if .....
Эта инструкция также подходит к моделям:Стиральные машины - WAS24444ME/04 (1.92 mb)
Стиральные машины - WAS24444ME/06 (1.92 mb)
Стиральные машины - WAS24444ME/07 (1.92 mb)
Стиральные машины - WAS24444ME/08 (1.92 mb)