Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
The guarantee applies to Gt, Britain and Northern Ireland only, and Is an addition to your statutory rights. Your appliance Is supplied with a registration card which should be completed and returned as Indicated. This should be kept in a safe place and presented to the Engineer If a service call is required. & CHAPTER 3 SAFETY MEASURES IMPORTANT: BEFORE CLEANING OR GENERAL MAINTENANCE • Remove ihe plug 9 Turn off the waler inlet tap. 9 All Candy appliances are earthed, ensure that the main electricity circuit is earthed. Contact a qualified electrician if this is not the case. This appliance complies with Directives 89/336/EEC, 73/23/EEC and the following changes. • Do not touch the appliance with wet or damp hands or feet. » Do not use the appliance when bare footed. Warning: this appliance must be earthed. WARNING: DURING THE WASH CYCLE, THE WATER CAN REACH A TEMPERATURE OF 90°C. • Before opening the washing machine door, ensure that there is no wafer inside the drum. i- " I @ \ 0 Do not use adapters or multiple plugs. 0 Do not allow the appliance to be used by children without supervision. 0 Do not puli the mains lead or the machine itself in an ai tempt to remove the plug from ihe socket. 0 Do not leave the appliance exposed to the natural elements (rain, sun, freezing etc.) 0 Importantf When placed on carpet or carpet tiles care must be taken to ensure that there is no obstruction to the bottom vents. 0 During transport do not lean the loading door against a trolley. 0 Lift the appliance In pairs as Illustrated in the diagram, 0 In the event of appliance failure and/or Incorrect operation, turn off the washing machine, disconnect the electrical supply and do not tamper with the appliance. Refer to the check list In chapter 13 for "possible reasons for the problem". Then if necessary contact the Candy Service Centre shown In the booklet supplied for repairs. CHAPTER 4 52 cm MAXIMUM DRY LOAD lbs 10 (4.5 kg) NORMAL WATER LEVEL Gall 4.2(191) ECONOMIC WATER LEVEL Gall 3 (151) POWER INPUT W 2050 ENERGY CONSUMPTION (PROG. V60 j INTENS) kWh 1.03 FUSE A 13 SPIN SPEED r.p.m. 400-1000 (CE 104/1) SPIN SPEED r.p.m. 400-1200 (CE 124/1) SUPPLY VOLTAGE V 240 (for U.K. only) 230 (others) WATER PRESSURE MPa min. 0,05 max. 0,8 & CHAPTERS SETTING UP INSTALLATION Remove the polystyrene base and place the machine near its permanent position (diagram I). Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2), Unscrew the central bolt (A); unscrew the 4 lateral screws (B) and remove the cross piece (C) (diagram 3). Lean the machine forward and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards (diagram 4). Press the plug (to be found in the envelope with the instructions) Into the hole and rotate to lock Into position (diagram 5). WARNING: DO NOT LEAVE THE PACKAGING IN THE REACH OF CHILDREN AS IT /5 A POTENTIAL SOURCE OF DANGER. 9 WATER CONNECTION Your machine may either be plumbed in or connected to existing taps, using a tap adaptor with a >3/4 B.S.P. threaded end connection. The water supply hoses to be found inside the drum are terminated in two different ways. One end which has a 90° elbow is to be connected to the appliance water connection E while the straight end is to be connected to the domestic supply tap. The hose with the white collar should be connected to the cold tap, and the hose with the red collar to the hot tap. The appliance is not suitable for use with mixer taps, Hook the end of the outlet hose over the rim of the sink or outlet pipe, making sure that It Is not kinked. For belter positioning of the outlet hose make use of the plastic bend provided. Where possible, use a fixed discharge pipe with a diameter greater Ihan that of the outlet hose this allows the air to escape. The minimum height of the top of the outlet hose should be 50 cm. Extending the outlet hose, especially if the extension is more than I metre, could lead to malfunctioning of the discharge. The appliance outlet hose should discharge info the foul water drainage system and not into the surface wafer drainage system. Should you require further advice please contact your local water authority, Apply the adhesive label supplied in the appropriate language onto the pull-out wash programme guide (R). (See chapter 6 - description of control panel). Level the machine by means of the front feet. a) Turn the nut clockwise to release the screw adjuster on the foot. b) Rotate the foot to raise or lower it until It stands firmly on the ground. c) Lock the foot in position by turning the nut anti-clockwise until it comes up against the bottom of the machine, Ensure that the ON/OFF button (see page 12, button C) Is not pressed and the load door is closed. © ELECTRICAL CONNECTIONS If the plug we supply does not fit CUT IT OFF AND DESTROY IT! You can't use it on other appliances, and 1he exposed wires could he ...
Эта инструкция также подходит к моделям:Стиральные машины - CE 124/1 (775.39 kb)