Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
• The drain filter is clogged. Check and tighten hose connections. Unclog drain pipe. Contact plumber if necessary. Too much detergent or unsuitable detergent may cause excessive foaming which may result in water leaks. Check another tap in the house. Fully open tap. Straighten hose. Check the filter of the inlet hose. Clean and straighten the drain hose. Clean the drain filter 38 Troubleshooting guide Symptom Possible Cause Solution Washer does not start Washer will not spin • Electrical power cord may not be plugged in or connection may be loose. • House fuse blown, circuit breaker tripped,or a power outage has occurred. • Water supply tap is not turned on. • Check that the door is firmly shut. Make sure plug fits tightly in wall outlet. Reset circuit breaker or replace fuse. Do not increase fuse capacity. If problem is a circuit overload, have it corrected by a qualified electrician. Turn on water supply tap. Close the door and press the Start/Pause button. After pressing the Start/Pause button, it may take a few moments before the washer begins to spin. The door must be locked before spin can be achieved. Add 1 or 2 similar items to help balance the load. Rearrange load to allow proper spinning. Door does not open Once machine has started, the door cannot be opened for safety reasons. Check if the "Door Lock" icon is illuminated. You can safely open the door after the "Door Lock" icon turns off. Wash cycle time The washing time may vary by the delayed amount of laundry, water pressure, water temperature and other usage conditions. If an imbalance is detected or if the suds removing programme is on, the wash time shall be increased. Fabric softener overflow Too much softener may cause an overflow. Follow softener guidelines to ensure appropriate amount is used. Do not exceed the maximum fill line Softeners dispensed too early Close the dispenser drawer slowly. Do not open the drawer during the wash cycle. Dry problem • Does not dry Do not overload. Check that the washer is draining properly to extract adequate water from the load. Clothes load is too small to tumble property. Add a few towels. 39 40 Symptom Possible Cause Solution • Water supply is not adequate in area. • Water supply taps are not completely open. • Water inlet hose(s) are kinked. • The filter of the inlet hose(s) are clogged. • If water leakage occurred in the inlet hose, indicator “..” will be changed red color. • Drain hose is kinked or clogged. • The drain filter is clogged. • Load is too small. • Load is out of balance. • The appliance has an imbalance detection and correction system. If individual heavy articles are loaded (e.g. bath mat, bath robe, etc.) this system may stop spinning or even interrupt the spin cycle altogether. • If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle. • Ensure door is not open. • Water overfills due to the faulty water valve. • Water level sensor has malfunctioned. • Over load in motor. • The washer experienced a power failure. • Check water supply. • Water leaks. Check another tap in the house. Fully open tap. Straighten hose(s). Check the filter of the inlet hose. Clean and straighten the drain hose. Clean the drain filter. Add 1 or 2 similar items to help balance the load. Rearrange load to allow proper spinning. Close the door completely. ..If “ ” is not released, call for service. Unplug the power plug and call for service. Close the water tap. Unplug the power plug. Call for service. Allow the washer to stand for 30 minutes to allow the motor to cool; then restart the cycle. Restart the cycle. Turn the tap on. If “ ” is not released, unplug power plug and call for service. Call for service. Error Messages Troubleshooting guide