Оценок - 3, средний балл: 3.7 ( )

Производитель: Daewoo Размер: 1.01 mb Название файла: Язык инструкции:

• Don’t earth to a gas pipe. • Don’t change the power supply cord plug. • Check with a qualified electrician if you are not sure the washer is properly earthed. Recommended earthing method C B A For your personal safety, this washer must be earthed. This washer is equipped with a power supply cord ‘A’ having a earthing plug ‘B’. To minimize possible shock hazard, the cord must be plugged into a mating earthing-type wall receptacle ‘C’. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have the proper earthed wall receptacle installed by a qualified electrician. Drain system • Never forget to install drain hose before operating your washer. • Open the packing box, and there is a drain hose inside the drum. • Connect the drain hose to the drain outlet at the back side of the washer. • Top of laundry tub must be at least 60cm high and no higher than 100cm from bottom of washer. • When installing the drain hose to tub(sink), secure it tightly with a string. • Proper securing of the drain hose will protect the floor from damage due to water leakage. • When the drain hose is too long, do not force it back into the washer. This will cause abnormal noise. Level adjustment 1 If the washer is installed on an unsuitable floor, it could make considerable noise, vibrate and cause a malfunction. 6 7 OPERATING YOUR WASHER 2Adjust the level of washer using adjustable legs. • Please check if there is any gap between the four adjustable legs and the floor. • Turning adjustable legs by the enclosed spanner, adjust the level of washer and make it sure that there is no swaying of washer. • After the adjustment is finished, turn the fixing nuts up tightly so that the washer maintains the adjustment. 3Make it sure that the washer does not sway when you press down the four corners of the washer's top plate. adjustable leg Fixing Nut NOTE There should be no swaying of washer and all the adjustable legs should stick to the floor closely. To obtain the best washing results, you must operate your washer properly. This section gives you this important information. • Close zippers, snaps, and hooks to avoid snagging other items. Remove pin, buckles, and other hard objects to avoid scratching the washer interior. • Empty pockets and pull them inside out. • Turn down cuffs and turn synthetic knits inside out to avoid pilling. • Tie strings and sashes to avoid tangling. • Treat spots and stains. (See “Removing stains” on page 21) Preparing clothes for washing Sorting • Separate heavily soiled items from lightly soiled ones, even if they would normally be washed together. • Separate dark colors from light colors, colorfast items from non-colorfast item. Soil (Heavy, Normal, Light) Separate clothes according to amount of soil. Color (White, Lignts, Darks) Separate white clothes from colored clothes. Lint (Lint producers, Collectors) Wash lint producers and lint collectors separately. • Drop items into washer loosely. Items should move easily through wash water for best cleaning and wrinkle-free results. • Load washer properly and select correct load size setting. Overloading and selecting a setting too small for the wash load can : - Cause poor cleaning - Increase wrinkling - Create excessive lint - Wear out items faster (because of pilling) • Mix large and small items in each load. Load evenly to maintain washer balance. An unbalanced load can make the washer vibrate during spin. • Reduce wash time when using a small load size setting. Load with only a few small items needs less wash time. • Use a large load size setting to reduce wrinkling with permanent press clothes and some synthetic knits. These items should have more room to move in the water than heavy items. (towels, jeans) Loading Adding detergent 1 Detergent case Main wash Fabric softener Pre wash 2 Adding fabric softener • If desired, add measured liquid fabric softener to the softener inlet. • Pour liquid fabric softener into the dispenser using the amount recommended on the package. • Do not exceed the maximum fill line. Overfilling can cause early dispensing of the fabric softener which could stain clothes. • Do not open the detergent case when water is supplied. • Avoid pouring fabric softener directly on the clothes. 8 THE FUNCTIONS OF THE CONTROL PANEL Press this switch to turn the power on or off. Operation and temporary stop is repeated as it is pressed. When you want to change program in operating; press the “Start/Hold” button >Select the program that you want to change >press the “Start/Hold” button again. You can select the course you want, and each lamp is turned on when that course is selected. For the more detailed information, please refer to the page 11~18. It can be used to adjust temperature of water according to types of the load to be washed. As the button is pressed, temperature of water is selected by Cold >30°C >40°C >60°C >95°C By pressing the spin button, the spin speed can be chosen. Rinse ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: