Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
Judge the amount according to the detergent manufacturer’s instructions and size of the load; • the water hardness: the harder the water, the more detergent required. Instructions according to water hardness are given on the detergent pack. Liquid detergent Liquid detergent can be poured directly into the main wash compartment of the dispenser drawer immediately before starting the programme, or a special dispenser can be used that is placed directly in the drum. Measure the detergent according to the manufacturer’s instructions. Adding a water softener (descaling product) A water softener must be added when water has a medium-high degree of hardness (from degree of hardness II). Follow the manufacturer’s instructions. The quantity of detergent can then always be adjusted to degree of hardness I (= soft). Information on water hardness can be obtained from your local water supply authority. Information on water hardness Degree of hardness German degrees °dH French degrees °TH I=Soft 0-7 0-15 II=Medium 7-14 16-25 III=Hard 14-21 26-37 IV=Very hard more than 21 more than 37 20 132986190.qxd 16/02/2005 11:56 Pagina 21 How to wash Load the laundry Open the door. Place the laundry in the drum, one item at a time. Distribute laundry as evenly as possible. Close the door. Add detergent and additive Pull the drawer out till it stops. Pour the main wash detergent into compartment . If you wish to perform a PREWASH, a SOAK or a STAIN-Action programme, pour detergent or stain remover into compartment . Important! Do not use normal detergent for the STAIN-Action programme, always use a STAIN remover. Pour the fabric softener into compartment without exceeding the “MAX” mark. Close the drawer gently, pushing it fully in. 21 132986190.qxd 16/02/2005 11:56 Pagina 22 How to wash Selection of the desired wash programme Turn the programme selector dial to the desired position: the lights corresponding to the different phases making up the selected programme light on. The display shows the duration of the programme. Selection of the desired options depending on the degree of soil of the laundry. The corresponding light comes on. Selection of the spin speed or RINSE HOLD option It is possible to select a lower spin speed 1046EL 1246EL by means of the relevant button; the . . . light corresponding to the selected speed . comes on. . . Selecting option (RINSE HOLD) the laundry is left immersed in the final rinse water. If the spin speed is not reduced , the final spin speed will be as follows: 1046 EL 1246 EL -cottons 1000 r.p.m. 1200 r.p.m. -synthetics 1000 r.p.m. 900 r.p.m. -delicates 1000 r.p.m. 900 r.p.m. -wool (hand washing) 1000 r.p.m. 900 r.p.m. 22 132986190.qxd 16/02/2005 11:56 Pagina 23 How to wash EXTRA RINSE This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse). The extra rinse is available only with the cotton, synthetics or delicate programme. Selection of the EXTRA RINSE option for about 3 seconds: the light amme progress display This function stays permanently on. To remove it press buttons SPIN SPEED and again until the light comes off. Selection of the DELAY START option To delay starting of a programme, press the DELAY START button before starting the machine. The figures corresponding to the selected delay will be displayed for about 3 seconds, after which the duration of the selected programme will appear on the display. If button (SOAK) has been pressed the selected delay will correspond to the soak time. If no delay time is selected the soak programme will last about 30 minutes. When the START/PAUSE button is pressed, the selected delay will appear again on the display and the machine starts its countdown. 23 132986190.qxd 16/02/2005 11:56 Pagina 24 How to wash Starting the programme 1. Check that the water tap is open. 2. Press START/PAUSE to start the programme. If the Delay Start option has been selected the programme will start at the end of the countdown. If the DOOR light is red and flashing for some seconds and when it goes out the END light starts flashing, the alarm code E40 appears in the display, it indicates that the door is open. Close the door and press the START/PAUSE button again. If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry, to cancel the delay time. • Load other laundry: press the START/PAUSE button. Open the door. Load the laundry. Close the door and press the START/PAUSE button again. • Cancel the delay time: press the START/PAUSE button. Press the DELAY START button until 0’ appears on the display. Press the START/ PAUSE button again. Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machi...
Эта инструкция также подходит к моделям:Стиральные машины - 1246 EL (656.56 kb)