Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
If the washer serial number is below XC703, proceed with instructions 10 through 12. 10. In slot number 2, insert a small wire (paper clip) between the locking tab of the red wire terminal and the housing. Note: The locking tab is located in the small rectangular slot below the terminal. DO NOT push down on the contact prongs on the wire terminal. 11. Pull the red wire out of the slot. 12. Insert the red wire into slot number 4 until the terminal clicks into the housing. Gently pull on the wire to ensure it is fully seated in the housing. 13. Remove the connector plug from the pump. NOTE: Removing the pump cover on pumps with an external cooling fan will make it easier to access the connector plug. 14. Connect the nine pin plug from the adapter harness to the to the SCU. P/N 131888800 8/99 15. Conncct the nine pin plug removed in step K to the connector board 011 the adapter harness. 16. Dress the adapter harness along side of the present washer harness as shown. 22. Using the plastic harness ties, attach the adapter harness to the washer harness. Dress (lie harness in such a manner that it will not interfere with any moving parts or cause any noise when the washer is in operation. ¡7. Conncct the green connector plug from the adapter harness to the pump. Re-install the pump cover, if if was removed in step 13. IS. Connect the green connector plug from the washer harness to the connector on the adapter harness. 19. NOTE: If the service kit's door lock is already prewired to the adapter harness, go to step 20. If the service kit’s door lock is not pre-wired to the adapter harness, connect the adapter harness connections to the new door lock. 20. Matching color for color, connect the door switch wires from the washer harness to the connectors in the adapter harness, 21. Install the new door lock to the washer cabinet using the same screws removed in step 6. 2}. Connect the washer to the elcctrical power source and lest for proper operation. Close the door, place the timer to the final spin position, and start the timer. When the machine starts its fast ramp up to the higher spin speed, turn the timer off, then quickly pull on the door handle to verify the door is locked. If the door opens, recheck the connections in steps 9 through 1?.. 24. Using the tube of adhesive, glue the bellows to the front panel at the 2, 3, & 4 o’clock positions. Wait about two minutes, then pull on the bellow to make sure it is securely bonded to the front panel. 25. Install the front service panel. t’-N niNXXKOO...