Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
DOOR MUST BE CLOSED TO START Insert coin(s) in coin slot. Check pricing as seen on WASHER. digital display. Figure 21 Figure 19 FLW2231N W387I 16 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 803148 Operation Indicator Lights INSERT COINS/CARD INSERT COINS/CARD is lit to prompt the user to insert coins or card to satisfy the vend price. When INSERT COINS/CARD is lit, the digits show the vend price remaining to be satisfied. WASH WASH is lit during the WASH portions of the cycle. RINSE RINSE is lit during the RINSE portions of the cycle. SPIN SPIN is lit during the final spin portion of the cycle. DOOR DOOR is lit whenever the door is locked. The door cannot be opened when this light is on. LIGHT LIGHT is lit when the LIGHT soil level is selected. MEDIUM MEDIUM is lit when the MEDIUM soil level is selected. HEAVY HEAVY is lit when the HEAVY soil level is selected. START START flashes one second on and one second off when the full vend price has been satisfied. IMPORTANT: If washer fails to operate properly after installation, make sure electrical service and water supply faucets are turned on. Are all the controls properly set? Have a qualified service person refer to the wiring diagram (located inside of washer control cabinet) and check for broken, loose or incorrect wiring. NOTE: Once a cycle has started, the door can only be opened by first unplugging the power cord and waiting one minute. WARNING To reduce the risk of bodily injury, do notremove laundry from washer until all lights are out, and all moving parts have stopped. W092 803148 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 17 Maintenance User-Maintenance Instructions Replacing Hoses Lubrication All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary. Do not lubricate the door hinge. If the hinge makes noise, replace the hinge. Cold Weather Care If the washer is delivered on a cold day (below freezing), or is stored in an unheated room or area during the cold months, do not attempt to operate it until the washer has had a chance to warm up. Care of Your Washer Use only a damp or sudsy cloth for cleaning the control panel. Some cleaning product sprays may harm the finish on the control panel or damage the interior of the hood. Wipe the washer cabinet as needed. If detergent, bleach or other washing products are spilled on the cabinet, wipe immediately. Some products will cause permanent damage if spilled on the cabinet. Do not use scouring pads or abrasive cleansers. The wash drum will need no particular care although it may need rinsing or wiping after an unusual load has been washed. The outside of the door window can be cleaned with household window cleaner. Running an occasional rinse cycle with bleach will help to avoid a musty smell in the wash drum. Cleaning Glass Sealing Area In order to assure that the door properly seals against water leaks, the following surfaces should be wiped off periodically: . The outside perimeter of the door glass where the seal contacts the glass . The front surface of the door seal lip Usually a mild soap solution will work. If there is an extreme build-up of minerals from a hard water supply, the surfaces may need to be cleaned with a lime removal chemical. Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to. All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. Filter Screens Check the filter screens in the fill hoses for debris or damage annually. Clean or replace them if necessary. If the washer is filling with water slower than normal, check the filter screens. Clean or replace them if necessary. Order filter screen Part No. F270300 from the nearest authorized parts distributor. Vacations and Extended Non-Use IMPORTANT: To avoid possible property damage due to flooding, turn off the water supply to the washer whenever there will be an extended period of non-use. Leave the loading door open during extended periods of non-use to allow the wash drum to dry out and avoid a musty smell. 18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 803148 Maintenance Reinstallation of Shipping Materials To prevent damage while moving the washer, the shipping materials MUST be reinstalled. . Disconnect washer from electrical supply. . While supporting the front access panel, remove two screws from the bottom edge of the panel. . Gently lower the panel to remove it from the washer. . Place the shock sleeves on all four shock absorbers. Refer to Figure 22. . Insert hooked end of shipping brace into the open slot of the motor mount. Refer to Figure 22. . Attach the brace ...