The control is still energized as long as the power switch is on. NOTE: To lock the spindle or to utilize the indexing feature, pull the spindle lock pin (A) Fig. 25 out and rotate the pin clockwise. Re-engage it in the pulley holes (B) Fig. 25, some of which are shown. The spindle pulley has 24 holes accurately spaced around the rim of the pulley. This feature makes it possible to make evenly spaced divisions on turnings which could be fluted, grooved, or to mark places to be drilled. CHANGING

This new 10HP ZX Series lathe boasts a 22" swing over bed and comes standard with a 10" 3-jaw chuck with top reversing jaws and a 12" 4-jaw chuck. The 22" ZX Series Large Spindle Bore Lathe comes equipped with a 3-1/8" bore spindle supported by two tapered bearings and one ball bearing and a universal gear box with pitch threads in inches, metric, diametral and module. The universal gear box is dial controlled eliminating the need for changing end gears. The GH-2280ZX also comes standard with a

1 29........ JWL1642-129 ...............Plate...................................................... ............................................... 1 ........JWL1642-130...............Digital Readout......................................JWL-1642EVS........................1 ............JWL1642-130A.............Digital Readout......................................JWL-1642EVS-2.....................1 31........ TS-1540011..................Nut ........................................................

BD920N-CS09......... .........Rivet............................................... ..................2x5................ ...........2 10 ... 5020......................... .........Graduated Ring.............................. ...........1 11... ... BD920N-CS11......... .........Key................................................. ..................3x13.............. ............1 12... ...5023......................... .........Spring............................................. ............1

Inc. LaVergne, TN USA ©WMH TOOL GROUP, Inc. All rights reserved. STOCK N0.900842 Printed in the U.S.A. 1-800-248-0144 The Gold Standard Since 1921.™

Ignoring this warning can lead to a severe crushing injury or finger amputation! Specifications • Fits Lathe Models ..14" x 40" SB1012, SB1013 ................................16" x 60" SB1014, SB1015 ............................... 16" x 40" SB1037, SB1038 • Taper Per Inch Range.............................0–18" • Minor Inch Scale Divisions....................0.010" • Major Inch Scale Divisions....................0.020" • Taper Angle Range .................................0–10° • Minor Taper Sca

4740 lbs. Length/Width/Height..................................................................................................................... 102 x 38-1/4 x 51 in. Foot Print (Length/Width)........................................................................................................................... 102 x 32 in. Shipping Dimensions: Type............................................................................................................................................

20) to desired rate. Note: for threading, lever (D) will be set at "C" or "E", depending on desired thread. 3. Push lever (B, Fig. 19) to the right. 4. Engage the half nut lever (C, Fig. 19). 5. To cut inch threads, reference the feed and thread tables. The half nut lever and the threading dial are used to thread in the conventional manner. The thread dial chart specifies at which point a thread can be entered using the threading dial. 6. To cut metric threads, the half nuts must be left continu

3. Move the point of skew to the right half of the desired width of your cut, see Figure 19. 4. With the bevel parallel to the right side of the cut, raise the handle and push the tool in to the desired depth. 5. Repeat from the left side. The two cuts should meet at the bottom and leave a clean "V" cut. 6. Additional cuts may be taken to add to either the depth or width of the cut. Parting 1. Place the parting tool on the tool rest and raise the handle until it starts to cut and continue to cut