#ts10612 printed in ChinA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#CR8520 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

#JB10401 PRINTED IN CHINA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

3. slightly loosen backlash setting (page 63). 4. lubricate bedways and handles. Bad surface finish. 1. Wrong rpM or feed rate. 2. dull tooling or poor tool selection. 3. too much play in gibs. 4. tool too high. 1. Adjust for appropriate rpM and feed rate. 2. sharpen tooling or select a better tool for the intended operation. 3. tighten gibs (page 61). 4. lower the tool position. inaccurate turning results from one end of the workpiece to the other. 1. headstock and tailstock are not properly al

Pump damage will cccur if it is run for a period of time without coolant. To perform regular maintenance on the cutting fluid system: 1. Remove the access cover at the rear of the lathe (Figure 56). Figure 57. Coolant pump switch. Figure 56. Coolant pump and reservoir. -42- G0509 & G0509G 16" x 40" Lathe SECTION 7: SERVICE Troubleshooting Review the troubleshooting and procedures in this section to fix your machine if a problem / .✓I® develops. If you need replacement parts or you are u

#TS8724 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

Feed clutch access covers removed. -68- V Qty .....1 .....1 .....1 3. Rotate the shroud washer so the cutout lines up with the shear pin head (Figure 127). Figure 127. Shroud washer/pin alignment. 4. Put on your safety goggles. 5. Using retaining ring pliers remove the retaining ring from its groove and place it in the rear most position away from the shroud washer (Figure 128). 6. Move the shroud washer away from the shear pin to the rear position so there is a gap to remove the shear

refer to the chart in figure 22 help choosing the correct spindle speed. note that both the diameter of the workpiece and the type of cutting determines the spindle speed. Diameter of Work- piece Roughing RPM General cutting RPM finishing RPM Under 2" 1520 3000 3000 2–4" 760 1600 2480 4–6" 510 1080 1650 6–8" 380 810 1240 8–10" 300 650 1000 10–12" 255 540 830 12–14" 220 460 710 14–16" 190 400 620 figure 22. model g0694 typical spindle speed recommendations. To change speed ranges: 1. disConneCt L

-16 G0456 Variable Speed Wood Lathe Adjusting Tailstock The tailstock is equipped with a cam-action clamping system to secure it to the lathe bed. When the lever is tightened, a locking plate lifts up and secures the tool rest to the bed. To position the tailstock along the bed: 1. Loosen the quick release and move the tailstock to the desired position (Figure 12). 2. Tighten the quick release. —If the quick release will not lock the tailstock down onto the bed (either too loose or too tight), l