Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. • Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. • For details regarding the connections on the amplifier side, refer to the manual that was provided with your amplifier. Tip All striped wires are minus (–) in polarity, and should be connected to the minus (–) speaker terminals. Positioning the speakers Location of each speaker Center Front (Left) Front (Right) Rear (Left) Rear(Right) Surround back Tips • Movies are best enjoyed in a room that produces no echoes (as in one with surrounding curtains). • Music (especially classical music) is best enjoyed in a room that produces some echo. Positioning the speaker (for SS-V811ED only) ( C) Attach the speaker to supplied speaker stand and place them at their optimum locations. For details on the location of the speaker, see “Location of each speaker” . 1 Detach the plate from the stand. 2 Pass the speaker cord into the hole on the back of the stand and out from the hole at the center of the stand. 3 Separate the speaker cord, then secure the cord to the speaker stand with the plate. 4 Connect the speaker cord to the speaker terminal. The cord should be pressed into the groove in the stand. 5 Using the supplied screws and washers, secure the speaker to the stand. Note Do not remove the supplied speaker grille from the speaker while attaching the speaker to the speaker stand. Setting the speaker (for SS-V521 only) ( D) To prevent speaker vibration or movement while listening, attach the supplied foot pads to the speaker. 2 3 Precautions On operation • Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. • If the polarity of the speaker connections are not correct, the bass tones will be weak and the position of the various instruments obscure. • Contact between bare speaker wires at the speaker terminals may result in a short-circuit. • Before connecting, turn off the amplifier to avoid damaging the speaker system. If you encounter color irregularity on a nearby TV screen This speaker system is magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. If color irregularity is observed... c Turn off the TV set once, then turn it on again after 15 to 30 minutes. If color irregularity is observed again... c Place the speakers further away from the TV set. If howling occurs Reposition the speakers or turn down the volume on the amplifier. On placement • Do not set the speakers in an inclined position. • Do not place the speakers in locations that are: — Extremely hot or cold — Dusty or dirty — Very humid — Subject to vibrations — Subject to direct sunlight On cleaning Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. 4 5 Specifications SS-V811ED (SS-MS815) Speaker system 2 way, magnetically shielded Speaker units Tweeter: 1.9 cm ( 3/ 4 in.), dome type Woofer: 5 cm (2 in.) . 2, balanced drive type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 140 W Sensitivity level 87 dB (1 W, 1 m) Frequency range 120 Hz - 70,000 Hz Dimensions (w/h/d) When attached speaker grille: Approx. 86 . 169 . 130 mm (3 1/ . 6 3/ . 5 1/ in.) 24 8 When attached to supplied speaker stand: Approx. 96 . 207 . 141 mm (3 7/ . 8 1/ . 5 5/ in.) 84 8 Mass When attached speaker grille: Approx. 1.3 kg (2 lb 14 oz) When attached to supplied speaker stand: Approx. 1.4 kg (3 lb 1 oz) SS-V521 (SS-MS525) Speaker system Full range . 2, magnetically shielded Speaker units 5 cm (2 in.), balance drive type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 120 watts Sensitivity level 87 dB (1 W, 1 m) Frequency range 120 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 89 . 144 . 130 mm (3 5/ . 5 3/ . 5 1/ in.) , 84 8 including front grille Mass Approx. 750 g (1 lb 10 oz) D Foot pads Supplied accessories Speaker stand (1) (SS-V811ED only) Screws (2) (SS-V811ED only) Washers (2) (SS-V811ED only) Plate (1) (SS-V811ED only) Foot pads (4) (SS-V521 only) Speaker connecting cords, 10 m (32 ft 9 3/ 4 in.) (1) Design and specifications are subject to change without notice. . 2001 Sony Corporation Printed in China Micro Satellite Speaker SS-V811ED/V521 Francais Fonctions Les instructions de ce manuel concernent le haut-parleur Sony Micro Satellite Speaker SS-V811ED et SS-V521. Si vous ajoutez ce haut-parleur aux systemes SAVE815ED et SA-VE525, vous beneficiez de l’effet ambiophonique comme avec un systeme acoustique a 6.1 voies. Lorsque que vous raccordez ce haut-p...
Эта инструкция также подходит к моделям:Акустика - SS-V811ED (76.87 kb)