Оценок - 2, средний балл: 5
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
This mode will be saved. 5 Connect the phone to your PC. Your phone will display Connected. NOTE: Your phone must be plugged into your PC to initiate mass storage. 67 Software Update LG Mobile Phone Software This section discusses how to update LG mobile phone software. For more information on installing and using this software, please visit The update feature allows you to update your software to the latest version quickly and conveniently over the internet, eliminating the need to visit our service centre. Since the mobile phone software update program requires the your full attention for the duration of the update process, please make sure to read the instructions and notes that appear at each step before proceeding. Note that removing the USB cable or batteries during the update process may seriously damage your mobile phone. LG assumes no liability for the loss of data during the update process. it is highly recommended to back up any important information before updating. 68 LG GD910 I User Guide Troubleshooting This chapter lists a number of problems you might encounter while using your phone. Some problems require you to call your service provider, but most are easy to correct yourself. Message Possible causes Possible Corrective measures SIM error There is no SIM card in the phone, or you may have inserted it incorrectly. Make sure that the SIM card is correctly inserted. No connection to the network Signal weak outside network Move to a higher location, a window or open space. Check the service provider coverage map. Codes do not match When you want to change a security code, you must confirm the new code, by entering it again. The two codes you have entered do not match. Contact your service provider. Function cannot be set Not supported by service provider or registration required. Contact your service provider. Calls not available Dialling error New SIM card inserted, Charge limit reached. New network not authorised. Check for new restrictions. Contact a service provider, or reset limit with PIN2. 69 Troubleshooting Message Possible causes Possible Corrective measures Phone On/Off key pressed Press On/Off key for at cannot be too briefly least 2 seconds. switched Battery empty Charge battery. Check on Battery contacts battery indicator on the dirty screen. Clean the contacts. Charging Battery completely Charge battery. error empty Make sure the Temperature out of operating range Contact problem No mains voltage Charger defective Wrong charger Defective battery surrounding temperature is within the operating range, wait, and then charge again. Check the power supply and connection to the phone. Check the battery contacts, and clean them if necessary. Plug in to a different socket, or check the voltage. If the charger does not warm up, replace it. Only use original LG accessories. Replace the battery. Phone loses network Signal too weak Reconnection to another service provider is automatic. Number The fixed dial Check settings. not number function permitted is on. 70 LG GD910 I User Guide Using the Bluetooth headset (LG HBM-900) The LG HBM-900 Bluetooth® Headset is a light, wireless Headset that uses Bluetooth® technology. it can be used as an audio accessory for devices that support either the Headset or Bluetooth® handsfree configurations. Back Speaker Charging Port 71 Using the Bluetooth headset (LG HBM-900) Change direction Charging - Remove the cover of the charging port, and then connect the charger. - When the charger is connected, the Headset will turn off automatically and cannot be used. - While charging, the LED indicator will display a blue light. - The buttons will not function while the device is charging. - It takes 2 hours to fully charge the Headset. - When charging is complete, the LED indicator will turn off. Using the Bluetooth headset (LG HBM-900) Low battery - A low-battery tone will sound once every 30 seconds. - If the battery is not charged, the Headset will turn off. Power on - Move the power switch from the OFF position to the ON position. • The power will turn on and a boot tone will play. Power off - Move the power switch from the ON position to the OFF position. • A shutdown tone will play, the Bluetooth link will disconnect and the power will turn off. Button hold - Button Hold mode prevents any button function of the Bluetooth headset from activated after unintentionally pressing a button. - “press and hold (two beep sound will be heard) the power switch to the HOLD position to place the headset in Hold mode. ” - press and hold the power switch to the ON position to turn off Hold mode. 73 Using the Bluetooth headset (LG HBM-900) - If you press any button on the headset while it is in Button Hold mode, you will hear three distinct beeps, and the LED will flash three times to alert you that the headset is in Hold Mode. - When you slide the power switch to th...
Эта инструкция также подходит к моделям:Радиотелефоны - GD910 - GD910 (5.26 mb)