Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Precautions
How to Use
• Make sure that the voltage and frequency indicated on
the bottom plate are the same as your local supply.
• Unplug when assembling or disassembling the unit.
• Close supervision is necessary when any appliance is
used near children.
• When carrying the unit, be sure to hold the motor housing
with both hands; do not hold only the hopper plate.
Before use
• Never feed food with hands. Use the food pusher.
Wash all the parts (except those that do not touch foods
a, b, c, and d ) in warm soapy water.
• Do not grind hard foods such as bones and nuts.
(They may cause jamming.)
Before plugging in, ensure the switch is off.
• Do not grind ginger and other materials with hard fiber.
(They will not be ground.)
To Grind Meat
• To avoid jamming, do not force to operate the unit with
(Assembling)
excessive pressure.
1 Place the head onto the opening of the motor
If the unit jams due to hard materials lodged onto the
housing. Holding the head with one hand, place the
feed screw or the cutting blade, switch off immediately
locking knob into the hole on the side of the motor
and clean the unit.
housing and tighten it clockwise.
When the circuit breaker activates, do not switch on.
(See "Caution on Jamming" on page 7.)
2 Place the feed screw into the head, long end first,
by turning the feed screw slightly until it is set into
• Never try to disassemble or repair the unit by yourself.
the motor housing.
• If the supply cord is damaged, it must be replaced by
3 Place the cutting blade onto the feed screw shaft
a special cord or a cord assembly available from your
with the blade facing the front as illustrated.
Panasonic dealer or its service agent.
(If it is not fitted properly, meat will not be ground.)
• Never remove or attach the hopper plate, the head or
4 Place the desired cutting plate next to the cutting
cap when the motor is operating.
blade, fitting protrusions in the slots.
• Do not disassemble the grinder or place anything
5 Screw the cap into place until tight.
(especially finger, spoon, fork, etc.) in the grinder during
(Do not over tighten.)
operation.
Place the hopper plate on the head and fix into
position.
• This product is intended for household use only.
Locate the unit on a firm surface.
(The air passage at the bottom and the side of the
motor housing should be kept free and not blocked.)
– 6 –
...