Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment. 7. The use of attachments not recommended or sold by the appliance manufacturer may cause fire, electric shock or injury. 8. Do not use outdoors. 9. Do not let cord hang over edge of table or counter, or touch hot surfaces. 10. Do not overload motor with extra heavy loads. 11. Always make sure Container Cover is clamped securely in place before motor is turned on. Do not unfasten Clamps while juice extractor is in operation. 12. Be sure to turn Switch to OFF position after each use of your juice extractor. Make sure the motor stops completely before disassembling. 13. Do not put your fingers or other objects into the juice extractor Feeder Opening while it is in operation. If food becomes lodged in Feeder Opening, use Food Pusher or another piece of fruit or vegetable to push it down. When this method is not possible, turn the motor off and disassemble juice extractor to remove the remaining food. 14. Always place a bowl, glass or cup under the spout. 15. Never wash the parts in hot water or expose them to excessive heat. 16. Do not wash washable parts in a dishwasher. 17. Do not assemble when there is food residue left around the base of the Strainer or Container. 18. All parts must be clean. Food particles left may cause odors, stains or prevent the Strainer from functioning properly. 19. This appliance is intended for home use only and not for commercial or industrial use. 20. Do not place appliance on or near hot gas or electric range. 21. To disconnect, grip plug and pull from wall outlet. Never pull on cord. 22. Make sure Strainer is completely stopped before removing Cover. 23. Never leave room while appliance is running. 24. This appliance should be used only for its intended use as described in the instruction manual. >AVE THESE INSTRUCTIONS Note: A. A short power-supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord. B. Extension cords are available and may be used if care is exercised in their use. C. If extension cord is used, (1) the marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance, and (2) the longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over unintentionally. D. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug dose not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. -2- IDENTIFICATION OF PARTS AND DISMANTLING Food Pusher Cleaning Brush Feeder Opening Opening for Brush Container Cover Strainer Coupler Motor Housing Clamp Switch TO DISMANTLE 1. Release Clamps as arrows indicate. 2. Lightly lift up the Container. The Strainer will come with it. 3. Remove the Container Cover. 4. The Strainer can be easily removed from the Container by lifting it out by the edges. 5. Remove the Spout Cover and clean the spout. Be sure to snap the Spout Cover completely back into place before using. 6. After dismantling each part, wash it in cold or lukewarm water except the Motor Housing. -3- HOW TO USE THE JUICE EXTRACTOR 1. Be sure the Clamps are correctly located and locked in position before using the juice extractor. 2. Place a glass or bowl under the spout. 3. Preparation of fruit and vegetables: • Cut large fruit and vegetables into smaller sizes so that they can be easily put into the Feeder Opening. • Strawberries, bananas, apricots, etc., are not recommended, as juice will not be thin as other fruits. 4. Plug the power cord into a convenient electrical outlet. Your juice extractor is ready for use. 5. Press the Switch “ON”. Then put the fruit and vegetables into Feeder Opening by using the Food Pusher. 6. After using, the Switch must be turned off and plug should be disconnected. CIRCUIT BREAKER PROTECTION When circuit breaker automatically stops motor due to overloading: after a 10 second interval, switch off. Unplug. Complete the following instructions, then resume operation. Cut ingredients small enough to fit into feeder opening. Push ingredi...