Оценок - 5, средний балл: 3.2
(
)
)
|
Фрагмент инструкции
The Power Juicer is not a toy. • Consult your physician before giving fresh juice to children, especially infants. • Be sure to turn to OFF position after each use of your Power Juicer • Make sure the lid is attached properly and securely locked before operating the Power Juicer. • Do not unfasten the locking bar during operation. • To avoid risk of injury keep hands and utensils out of the Power Juicer and away from its sharp blade during operation. • Use the pusher, not fingers or utensils, to propel the food into the Power Juicer. • Should food become lodged in the opening use pusher to push it down. If food remains stuck, turn the power off, wait until motor stops, Power Juicer shuts down completely, and is unplugged before disassembling the juicer and removing the blocked food. • Make sure the motor stops completely and the Power Juicer is unplugged from the electrical outlet before cleaning, putting on or removing parts. • To protect against risk of electrical shock or injury, never immerse power cord, plug, or Power Juicer in water, or other liquids. • If juicer stops due to improper operation or if there is excessive noise, turn power off, wait for blade to stop spinning, unplug from electrical outlet, disassemble and clean all components then reassemble Power Juicer. • Do not use Power Juicer outdoors. • Do not operate Power Juicer with a damaged cord or plug. • Do not operate if Power Juicer malfunctions, is dropped or damaged in any manner. Let a qualified appliance repair person examine and or repair appliance before using. • To avoid electric shock or serious injury do not use any attachments that were not recommended or sold by the manufacturer. • Do not let power cord hang over the edge of table, counter, or let cord touch hot surfaces such as stoves. • To reduce the risk of injury, never place blade on base without properly assembling the Power Juicer. • The Power Juicer has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify or force the plug in any way. • The Power Juicer motor will not run if unit is not properly assembled. The motor has a built-in safety feature that will not let the power turn on unless the locking bar is locked in place. JACK LALANNE POWER JUICER HELPFUL HINTS Obtain the best results from your Jack LaLanne Power Juicer by following these helpful hints. • Any fruit or vegetable that will fit the chute can be put through whole. The only time it is necessary to cut is when something is too large. Then it should be cut into large enough pieces to fit in the chute. Do not cut pieces too small. • Do not force food into the juicer. Allow food to pass through slowly and steadily using the pusher. You do not need to apply pressure unless the juicer starts to vibrate. Then only a slightly harder push should bring it back to balance. • Do not put any fruit or vegetables in your machine until power is turned on. • Allow unit to run for at least 10 seconds before juicing. • Remove large pits such as peach, mango, etc. as they will damage the blade and possibly the unit. • Cleaning can be made easy by placing a plastic bag inside the pulp collector container. When you are done juicing, the bag can be lifted out and disposed of easily leaving the pulp collector easier to clean. • Let the Power Juicer run for a few minutes before turning off to allow any excess juice to be extracted from the pulp. Once turned off it is quite normal for the juicer to spin for a minute or so due to the very fine precision balancing of this appliance. Wait until Power Juicer it is done spinning before disassembling. • Do not use bananas or avocados as they do not contain juice and will clog machine. Add them separately in a blender. • We do not recommend using overripe fruit as it will leave too much pulp in the filter and clog the Power Juicer. • Do not pour liquids into the Power Juicer at any time. SAVE THESE INSTRUCTIONS JACK LALANNE POWER JUICER ASSEMBLY Assemble as shown STEP 1: Place base on a dry flat surface with locking bar in down position as shown. In front of the machine (spout side). STEP 2: Place receptacle on the base, with juicer spout facing direction of locking bar. Settle receptacle into alignment. STEP 3: Place filter inside receptacle, matching the opening on its bottom to the screw peg connected to the base. Receptacle Juice Spout Base Lip Base Front of Machine (Spout side) Filter Receptacle 23 1Locking Bar JACK LALANNE POWER JUICER ASSEMBLY(CONT.) STEP 4: Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes in the blade and turn clockwise Crescent until tightened. Tool IMPORTANT: Do not over tighten as the Blade screw peg will break. Holes Remove crescent tool and set aside. CAUTION: Do not leave ...