Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
ALWAYS COVER vent hole when pushing primer. See warm engine restart “NOTE” above. D. Grasp starter handle (see Figure 1) and pull rope out, slowly, until it pulls slightly harder. Let rope rewind slowly. Then pull rope with a rapid full arm stroke. Let rope return to starter slowly. NOTE: If RECOIL STARTER is frozen and will not crank engine, proceed as follows: 1. Pull as much rope out of starter as possible. 2. Release starter handle and let it snap back against starter. NOTE: The above should be done only when necessary to free a frozen starter. E. Repeat instruction D until engine starts. If engine fails to start, repeat instructions С and D as necessary, until engine starts. F. When engine starts, move choke gradually to “OFF”. G. If engine falters, move choke immediately to “FULL” and then gradually to “OFF”. © ELECTRIC STARTER (see Figure 5)_ A WARNING: THE 120V A.C. STARTER IS EQUIPPED WITH A THREE- **WIRE POWER CORD AND PLUG, AND IS DESIGNED TO OPERATE ON 120V A.C. HOUSEHOLD CURRENT. THE STARTER MUST BE PROPERLYGROUNDEDATALLTIMESTOAVOIDTHE POSSIBILITY OF INJURY OR DEATH FROM ELECTRICAL SHOCK. DETERMINE THAT YOUR HOUSE WIRING IS A GROUND FAULT INTERRUPTED (G.F.I.) THREE-WIRE GROUNDED SYSTEM, OR ASK A LICENSED ELECTRICIAN IF YOUR ARE NOT SURE. IF YOUR HOUSE WIRING SYSTEM IS NOT A G.F.I. THREE-WIRE GROUNDED SYSTEM, DO NOT USE THIS ELECTRIC STARTER UNDER ANY CONDITION. IF YOUR HOUSE WIRING SYSTEM IS GROUNDED BUT A G.F.I. THREE-PRONG WALL RECEPTACLE IS NOT AVAILABLE AT THE LOCATION YOUR STARTER WILL BE USED, ONE SHOULD BE INSTALLED BY A LICENSED ELECTRICIAN._ NOTE: If your engine is equipped with a 12V battery-operated electric starter, disregard instructions regarding power cord. STARTING (continued) A. Connect power cord to switchbox on engine. B. Plug other end of power cord (see Figure 5) into wall receptacle. IMPORTANT: When connecting power cord, always connect power cord to switch box on engine first; then into wall receptacle. C. Move equipment control (see equipment manufacturer’s instructions) or engine control lever to “FAST” or “START position. D. Move engine choke to “FULL”. E. Push primer three times, making sure to cover vent hole when pushing (see Figure 4). Figure 4 NOTE: If restarting a warm engine after a short shutdown: 1. Leave choke in "OFF" position. 2. Push primer one time only. F. Push starter button (see Figure 5) or turn ignition switch key (see equipment manufacturer’s instructions) to crank engine. G. When engine starts, release starter button and move choke gradually to “OFF”. H. If engine falters, move choke immediately to “FULL” and then gradually to “OFF”. I. Disconnect power cord (see Figure 5) from wall receptacle first, and then from switchbox on engine. IMPORTANT: When disconnecting power cord, always unplug wall receptacle end first; then unplug switchbox on engine. NOTE: The electric starter is thermally protected. If overheated, it will stop automatically and can be restarted only when it has cooled to a safe temperature (a wait of approximately 5-10 minutes is required). If, after following the preceding instructions, the engine does not start, have it checked by your Authorized Tecumseh ...
Эта инструкция также подходит к моделям:Снегоочистители - 100 (1.28 mb)
Снегоочистители - 130 (1.28 mb)
Снегоочистители - 90 (1.28 mb)
Снегоочистители - OHSK80 (1.28 mb)