Войти:
Оценок - 3, средний балл: 3.7 ( )

Инструкция по эксплуатации Cannon, модель CHICHESTER 10420G

Производитель: Cannon
Размер: 402.51 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


To move the cooker forward, open the top oven/grill door and with both hands positioned under the roof of the compartment, lift and pull forward. Replace by pushing the cooker backwards. Check that the cooker is level. Take care to ensure that any floor covering is not damaged. MAIN OVEN HEAT CLEAN LININGS The oven back and side linings are coated with a special enamel which has a continuous cleaning action. The higher the oven temperature the more effective the action. In most cases this cleaning operation will proceed during normal cooking. However, if roasting is done frequently, or high temperatures are not used regularly, it may be necessary to run the oven empty at Mark 8 for about two hours. It should not normally be necessary to clean the linings with water, but if desired, wipe them over with a soapy cloth, followed by a wipe with a damp clean cloth. REPLACEMENT OF OVEN LIGHT BULB CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK. Light bulbs are not covered by the manufacturer’s guarantee. A new 15W, 300°C rated SES bulb can be obtained from your cooker supplier or any major electrical retailer. 1. Remove the shelves from the oven. 2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely event of a lens fracture. 3. Unscrew bulb. 4. Fit new bulb and refit lens. CARE AND CLEANING COOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate (Chichester & Traditional), pan supports, burner caps, roasting dish, grill pan, main oven base, inside of grill compartment Cloth wrung out in warm soapy water. Stubborn stains can be removed with a cream paste, liquid cleaner or by rubbing with fine steel wool soap pads. Check that the cleaning agent is approved by the Vitreous Enamel Association. Paint Plinth, control panel (trim), side panels, doors (trim). Wash with a cloth wrung out in warm soapy water only. DO NOT USE ABRASIVES. Aluminium Hotplate side trims, hotplate burner bodies, lid rear trim, rear flue grille. Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from the hotplate burner bodies. Glass As for enamel cleaning. Polish with a clean dry cloth or kitchen roll. Chromium Plating Oven shelves, grill pan grid, grill pan handle support Wipe with a cloth wrung out in warm soapy water. A fine steel wool soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner may be used. Plastic Grill pan handle, control knobs Wipe with a cloth wrung out in warm soapy water. Stainless Steel (Professional) Door trims, control panel, hotplate Wipe with a cloth wrung out in warm soapy water. Polish with a clean dry cloth or kitchen towel. For stubborn stains use a proprietary stainless steel cleaner and follow the instructions on the container. SOMETHING WRONG WITH YOUR COOKER Before contacting your Service Centre or Installer, check the problem guide below, there may be nothing wrong with your cooker. Burner ports Ignitor Burner ports Ignitor PROBLEM CHECK If all burners fail to ignite: Check that sparks appear at the burners; a clicking Ignition does not work. noise should be heard. If not; Oven burner Check that the electricity supply is turned on. If the electricity supply has failed, the hotplate, grill and top oven burners can be lit by a match. If only one burner fails to ignite: Check that the burner is dry and that spillage of food or cleaning fluid remains are not affecting the ignitor or burner ports. Clean away any debris with a dry nylon brush such as an old toothbrush. If a wire wool pad has been used for cleaning around the burner ensure the ignitor is free from any stray strands. Any water on the burner should be dried with a cloth or kitchen towel. Grill burner Hotplate burner On the hotplate make sure that all the burner parts are correctly seated. Burner ports Ignitor SOMETHING WRONG WITH YOUR COOKER Cannot set an “Auto Cook” programme or cannot get the timer to turn the oven on or off at the required times. Oven lamp does not work PROBLEM Main oven does not work, but the grill, top oven and hotplate burners work. Slight odour or small amount of smoke when grill / oven used first time Oven cooks too fast or too slow Timer Display shows "0:00" with "Auto" Flashing. Read the Timer instructions in this book carefully remembering that the Cook period is the length of time that the timer will switch the oven(s) on as part of an Auto Cooking Programme. The oven lamp is not covered by the guarantee. The part is easily changed (see the section on oven lamp replacement). A new lamp may be obtained from our Spare Parts department, see Key Contacts (back page). CHECK The timer may be set for an Auto Cooking Programme. Check the timer to see if “AUTO” is illuminated. If it is, follow the instructions given in the timer section of this book to cancel the Auto Cooking Programme. This is normal and should cease after a short period. Check that the gas mark an...

Эта инструкция также подходит к моделям:
Скороварки - CHICHESTER 10427G (402.51 kb)
Скороварки - CHICHESTER 10675G (402.51 kb)
Скороварки - CHICHESTER 10673G (402.51 kb)
Скороварки - CHICHESTER 10670G (402.51 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории