(Illustration shows optional accessories that may not be installed on your machine.) English 2Operating Instructions The following Operating Instruction manuals are included with this machine. Please refer to the appropriate manual and keep all manuals for future reference. If you lose the manual, contact the authorized Panasonic dealer. 2Operating Instructions The following Operating Instruction manuals are included with this machine. Please refer to the appropriate manual and keep all manuals

• Before operating this unit, please read these instructions completely and keep them carefully for future reference. • This unit is designed for installation by a qualified servicing dealer. Installation performed by non-authorized individuals could cause safety-related problems with the operation of this equipment. For U.S.A. only: • To locate the closest authorized dealer in your area, please call 1-800-449-8989. Stand is sold separately. Introduction Introduction n Thank you for purchasing t

Provide this information when contacting customer support. Serial No: SW ID: HW Ver: Boot Ver: Prod ID: Board ID: Burn Date: Burn Loc: If you have questions or concerns Contact Technical Support: •Phone: 1-800-228-7667 •Website: •Mail:SPX Service Solutions • 15825 Industrial Parkway • Cleveland, Ohio 44135 • Attn: Technical Support Copyright Information Copyright © 2006-2007 SPX Corporation All rights reserved. The information, specifications and illustrations in this guide are based on the late

This manual contains detailed instructions on the operation and maintenance of this copier. To get maximum versatility from this copier, all operators should carefully read and follow the instructions in this manual. Please keep this manual in a handy place near the copier. Please read the next section before using this copier. It contains important information related to USER SAFETY and PREVENTING EQUIPMENT PROBLEMS. SAFETY INFORMATION When using your copier, the following safety precautions sh

A USB port is labeled with the USB icon . Chapter 3: Installing the Scanner for Macintosh Chapter 4: Making Your First Scan Place a color photograph face down on the glass plate with the top side against the middle of the front ruler. 2 The optical performance of a CCD scanner is always best near the middle of the glass plate. However, the specified scan quality is guaranteed for the entire scan area. If you put more than one original on the glass plate, position them as close to the center line

Print Cartridge Holder 3. Remove by pulling the tape seal that is affixed to the print cartridge holder and the paper guide. 4. Pinch slightly together the handles of the closing lever to release it from its cartridge tray holder and turn it upwards to open the tray holder. 5. Remove the new print cartridge from its pouch. 6. Remove protection tape from the print cartridge. ATTENTION Do not touch the metal part of the cartridge nor put the tape back on again. 7. Insert the print cartridge into t

The main difference between the various models is the output signal scan rate (doubled / undoubled), the size of the case (1/2 rack or full rack), and the type of connectors used for audio and video connections. In the IN1510 and IN1710 decoders, the Composite Video or S-Video input signals are decoded and output as an RGB interlaced video signal at the same frequency as the original signal. The IN1222 and IN1422 scan doublers first decode the input signal (using the same circuitry as the IN1510

Specifi cations or version may be subject to change without notice. The actual specifi cation and version are based on the product delivered. Introduction Scanning a series of programming bar code labels can confi gure the scanner. The scanner must be properly powered before programming. The scanner will acknowledge a good and valid programming barcode label reading with two beeps and a green enlightening. It will give two other beeps (lower tone) and a red enlightening of the RSL led for either

No warranty of any kind is made in regard to this material, including, but not limited to, implied warranties of merchantability or fitness for any particular purpose. We are not liable for any errors contained herein or for incidental or consequential damages in connection with furnishing, performance or use of this material. We shall be under no liability in respect of any defect arising from fair wear and tear, willful damage, negligence, abnormal working conditions, failure to follow the ins

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 1 • Parts Guide MODEL Reference MODEL 1 AL-1631 AL-1215/AL-1540CS (SPF section) 2 AL-1641CS AL-1540CS/AL-1551CS (Duplex section) 3 AL-1645CS AL-1540CS (without SPF, with Duplex) Parts marked with “ ” are important for maintaining the safety of the machine. Be sure to replace these parts with the replacement parts specified to maintain the safety and performance of the machine. This document has been published