Войти:
Оценок - 1, средний балл: 3 ( )

Инструкция по эксплуатации Bolens, модель 692 and 693

Производитель: Bolens
Размер: 554.82 kb
Название файла: bd34b94a-434e-1344-2dfa-96f415f93b7b.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


If you violate any of these rules, you may cause serious injury to yourself or others. 1. Read this operating and service instruction manual carefully. Be thoroughly familiar with the controls and proper use of the power leaf blower. 2. Never allow children to operate this power leaf blower. 3. Keep the area of operation clear of all persons, particularly small children and pets. 4. Check fuel before starting engine. Do not fill fuel tank indoors, when engine is running, or while engine is hot. Wipe off any spilled fuel before starting engine. 5. Do not change engine governor settings. 6. Do not put hands near rotating parts for any reason. 7. If the power leaf blower should start to vibrate abnormally, stop the engine and check immediately for the cause. Vibration is generally a warning of trouble. 8. Before cleaning, repairing or inspecting, make certain all moving parts have come to a complete stop. Disconnect spark plug wire and keep wire away from plug to prevent accidental starting. Also keep throttle control lever in the stop position. 9. If the power leaf blower should become blocked with debris at any point, shut engine off and wait until the impeller comes to a complete stop before attempting to remove the obstruction. Disconnect spark plug wire to prevent accidental starting. 10. Check all bolts for tightness at frequent periods. 11. Never store this power leaf blower with fuel in the tank. Allow engine to cool before storing in any enclosure. 12. Keep bag and equipment free of debris when not in use. 13. Never operate this power leaf blower unless impeller guard and guard assembly are properly affixed in their places. 14. Never change inlet nozzle or auxiliary hose attachment when engine is running. 15. The manufacturer recommends that the operator wear safety glasses or some other suitable eye protection when operating this machine. 16. Exercise caution whenever operating leaf blower. Do not allow discharge to be pointed in the direction of persons. 17. No one should operate this unit while intoxicated or while taking medication that impairs the senses or reactions. UNPACKING Remove the leaf blower, hardware pack, loose parts and all literature from the carton before discarding carton. CONTENTS OF HARDWARE PACK (See Figure 1) A (2) Carriage Bolts B (2) Hand Knobs C (2) Hex Sems Bolts A**“ PARTS IN CARTON (See Figure 2) D (1) Upper Handle E (1) Directional Discharge FIGURE 1. FIGURE 2. ASSEMBLY INSTRUCTIONS FIGURE 3. IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After assembly, service engine with gasoline and oil as instructed in the separate engine manual packed with your unit. NOTE: Reference to right or left hand side of the leaf blower is observed from behind the unit in the operating position. ATTACHING THE UPPER HANDLE Place the upper handle (D) over the lower handle, lining up the holes in the upper handle with the middle holes in lower handle. Secure with carriage bolts (A) -<-and hand knobs (B). See figure 3. Directional Discharge (E) ATTACHING THE DIRECTIONAL DISCHARGE Slip end of directional discharge (E) over chute opening. Secure in position with hex sems bolts (C). See -^-figure 4. FIGURE 4. OPERATION BEFORE STARTING ENGINE Service engine with gas and oil. See engine manual packed with leaf blower for complete instructions for care and maintenance of engine. Read directions carefully. A WARNING: Revolving blades — keep hands away from all openings. TO START ENGINE After the engine has been properly fueled and oiled (refer to engine operating and maintenance instructions), start engine as follows. 1. Move choke lever on engine to CHOKE position. (A warm engine may not require choking.) 2. Move throttle control lever on engine to FAST position. 3. Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Let the rope rewind slowly. 4. Pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle. Let rope rewind slowly. Do not let starter handle snap back against starter. 5. Repeat instructions 3 and 4 until engine fires. When engine starts, move choke control gradually to RUN position. 3 TO STOP ENGINE 1. To stop engine, move throttle control lever to OFF position. 2. Disconnect spark plug wire and ground to prevent accidental starting while equipment is unattended. ADJUSTMENTS A WARNING: Do not at any time make any adjustment to the unit without first stopping engine and disconnecting spark plug wire. TWO-WAY DISCHARGE The leaf blower can be adjusted to discharge toward the front of the unit or to the side. Simply push down on the handle and swing door toward the front to discharge out the side, or to the side to discharge out the front. See figure 5. FIGURE 5. HEIGHT ADJUSTMENT The height adjustment crank is located on the right hand side of the leaf blower. See figure 6. Turn the crank clockwise to ra...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории