Оценок - 4, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
After fueling, tighten fuel cap as securely as possible by hand. BG 55, BG 55, SH 85 English / USA BG 85, SH 85 Observe safety precautions - see chapter “Safety Precautions”. Start as follows: : Set switch ( 1) to position I : Squeeze the throttle trigger ( 2) and move the setting lever ( 4) to midway 412295BA031 KN 295BA015 KN 56295BA016 KN position at the same time. : Release the throttle trigger, this is the starting throttle position. The setting lever enables you to select and hold any throttle position between idle and full throttle. Move the setting lever to the idle position before shutting off the engine. All models Set the choke lever (5): For cold start to g For warm start to e : Press fuel pump bulb ( 6) at least five times. : Place the unit on the ground. : Make sure you have a firm footing: Hold the unit firmly on the ground with your left hand on the handle and press down. : Pull the starter grip slowly with your right hand until you feel it engage and then give it a brisk strong pull. Do not pull out the starter rope all the way - it might break. BG 55, BG 65, 55, SH 85 English / USA : Do not let the starter grip snap back. Guide it slowly back into the housing so that it can rewind properly. If the engine does not start after 10 pulls with the choke lever set to e : Set choke to g , pull the starter rope five times, set choke to e and continue cranking. If engine is warm: : Continue cranking until engine runs (choke lever to e ) 5 To stop the engine: : Move switch to position O Additional hints on starting - If the engine does not start: : Make sure all settings are correct (choke shutter, throttle trigger in starting throttle position, stop switch to I) 295BA043 KN As soon as engine runs : Repeat the starting procedure : BG 55, 65, SH 55 Blip the throttle trigger so that interlock button pops out and the - If the engine still does not start: : Move switch to O : Pull off the spark plug boot ( 7). 7295BA017 KN If the engine is cold: engine settles down to idle speed : BG 85, SH 85 (choke position g) : Pull the starter rope five times. Move setting lever forwards to end position. : Move the choke lever ( 5) to e : Continue cranking until engine runs. If the engine stops during warm-up or acceleration: : Repeat starting procedure as described under “If engine is cold” Your unit is now ready for operation. : Unscrew and dry off the spark plug. : Open throttle wide. : Crank the engine several times with the starter to clear the combustion chamber. BG 55, BG 55, SH 85 English / USA : Refit the spark plug and connect the spark plug boot – push it down firmly. : Move switch to I : Set choke lever to e even if the engine is cold. : Now start the engine. 6295BA018 KN Fuel tank run until dry and thenrefueled : Press the fuel pump bulb ( 6) at least five times – bulb must be filled with fuel. : Now start the engine. Using the Blower 326BA033 LA Your blower is designed for one-handed operation. It can be carried by the control handle in either the right or left hand. The round nozzle* is particularly suitable for use on uneven surfaces (e.g. fields and lawns). The fan nozzle* produces a broad and powerful airstream at ground level. It can be aimed and controlled very accurately. This nozzle is highly effective for blow- sweeping sawdust, leaves, grass cuttings, etc. on flat surfaces. Watch out for small animals when using the blower on open ground, in yards and gardens. * see “Guide to Using this Manual” BG 55, BG 65, 55, SH 85 English / USA Using the Vacuum Shredder Working techniques To minimize blowing time, use rakes and brooms to loosen debris before blowing. Recommended working techniques to minimize airborne debris and pollution: : In dusty conditions, slightly dampen surfaces. : Use the full blower nozzle extension so the air stream can work close to the ground. : Do not direct debris at people, children, pets, at open windows or freshly-washed cars. Blow debris safely away. : After using blowers, CLEAN UP. Dispose of debris in trash receptacles. Do not blow debris onto neighboring properties. Recommended working techniques to minimize noise: : Operate power equipment only at reasonable hours - not early in the morning, late at night or during the noon-break when people might be disturbed. Comply with times listed in local ordinances. Usual recommendations are 9: 00 a. m. to 12:00 a.m. and 03:00 p.m. to 5:00 p.m. on workdays for professionals. Special considerations should be given to neighbors on weekends. : Fewer engines mean less noise; therefore use only one piece of power equipment at a time, when possible. : Operate power blowers at the lowest possible throttle speed to do the job. : Check your equipment before operation, especially the muffler, air intakes and air filters. Conserve water by using power blowers instead of hoses for those lawn and garden applications where a blower can be properly used, such as cleaning patios or porches. 295BA002 KN Your vacuum shredder is designed for tw...