Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Always loosen fuel caps slowly allowing pressure to equalize. • NEVER refuel a unit when the engine is HOT! • NEVER refuel a unit with the engine running. • DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground. • Securely tighten fuel cap after refueling. • Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired. After use • DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container. Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a well-ventilated, unoccupied building, away from sparks and flames. Do not store fuel longer than 30 days. IMPORTANT Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added. IMPORTANT Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use. Power Blower Operator’s Manual /- Operation • Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly. • (PB-403H): Rotate spring loaded throttle arm downward to a comfortable operating position. STARTING COLD ENGINE PB-403H 1. Throttle Lever Move throttle lever (A) to IDLE DETENT position. PB-403T 1. Throttle Lever/Stop Switch Move throttle lever (A) forward to idle position. Slide stop switch (B) forward to run position. PB-403H, PB-403T 2. Choke Move choke (C) up to Cold Start position (|'*.|). 3. Primer Pump primer bulb (D) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times. 4. Recoil Starter Pull recoil starter handle (E) until engine fires (5 pulls maximum). 5. Choke Move choke (C) down to run position (| \ | ), and if necessary, restart engine. NOTE If engine does not start after 5 pulls, move choke to "Cold Start" position, and repeat steps 4 & 5._ NOTE Allow engine to warm up before use. 16 (UtECHO, STARTING WARM ENGINE PB-403H 1. Throttle Lever Move throttle lever (A) to IDLE DETENT position. PB-403T 1. Throttle Lever/Stop Switch Move throttle lever (A) forward to idle position. Slide stop switch (B) forward to run position. PB-403H, PB-403T 2. Recoil Starter Pull recoil starter handle (E) and engine should start. Do not use choke (C). NOTE If engine does not start after 5 pulls, use cold start procedures. PB-403H a STOPPING ENGINE PB-403H 1. Throttle Lever Move throttle lever (A) to idle detent position and allow engine to return to idle before shutting off engine. 2. Throttle Lever Move throttle lever (A) to "O" (Stop) position. PB-403T 1. Throttle Lever Move throttle lever (A) forward to idle position and allow engine to return to idle before shutting off engine. 2. Stop Switch Slide stop switch (B) to Stop position. A WARNING MA DANGER If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using blower again. Power Blower Operator's Manual OPERATING BLOWER WARNING Mm DANGER Always wear safety glasses, hearing protection, a face filter mask and take all safety precautions or serious personal injury may result. Do not point the blower pipe in the direction of people or pets. Read the Safety Section on pages 4 - 6 carefully. IMPORTANT To avoid engine damage due to over-revving, do not block blower pipe opening. 1. Use only during appropriate hours. 2. Allow the engine to warm up at a fast idle for a few minutes. 3. Set engine speed with throttle lever (A). 4. Use lower speed to blow dry leaves from walks, patios and drives. 5. Additional speed may be necessary to clean grass and leaves from a lawn or flower bed. 6. Higher speed may be necessary to move gravel, dirt, snow, bottles or cans from a driveway, street, parking lot or stadium. NOTE Never use a higher speed setting than necessary to perform a task. Remember, the higher the engine speed, the louder the blower noise Minimize dust by using blower at lower speeds and by dampening material with water/mist when necessary. Keep debris on your property. Be Smart - be a good neighbor. V s- Maintenance Your ECHO blower is designed to provide many hours of trouble free service. Regular scheduled maintenance will help your blower achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded. If task is not listed, see your ECHO Dealer for repairs. SKILL LEVEL Level 1 = Easy to do. Most required tools come with unit. Level 2 = Moderate difficulty. Som...
Эта инструкция также подходит к моделям:Системы вентиляции - PB-403T (391.03 kb)