Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
Engine speed is reduced. Heat sensor is activated, due to restricted air flow at intake cover. Stop the engine. Clean debris blocking intake cover. Restart. Idle more than 1 minute. If engine speed is reduced again, consult with an authorized servicing dealer. Troubleshooting Guide ADDITIONAL PROBLEMS Remedy Possible Cause What To Check Clogged air filter. Clean or replace the air filter. Poor acceleration. Replace the fuel filter. Clogged fuel filter. Consult with an authorized servicing dealer. Lean fuel/air mixture. Adjust: 2,000 (±200) min-1. Idle speed set too low. Reset the switch and re-start. Ignition switch turned off. Fuel tank empty. Refuel. See Fuel section of manual. Engine stops abruptly. Clogged fuel filter. Replace fuel filter. Water in the fuel. Drain; replace with clean fuel. See Fuel section of manual.. Shorted spark plug or loose terminal. Clean or replace spark plug. Check the Specifications page in this manual for the proper spark plug for your unit. Tighten the terminal. Ignition failure. Replace the ignition unit. Consult with an authorized servicing dealer. Piston seizure. Test and replace as required. Ground (stop) wire is disconnected or switch is defective Engine difficult to shut off. Replace the spark plug. Check the Specifications page in this manual for the proper spark plug for your unit. Overheating due to incorrect spark plug Overheated engine. Idle engine until cool. Debris build up in impeller. Clean debris from impeller as required. Excessive vibration. Loose or damaged impeller. Inspect and replace impeller as required. Loose or damaged engine mounts. Tighten or replace engine mounts as required. Blower intake or discharge ports or tubes are clogged with debris.. Inspect and remove debris. Engine overspeeding. Consult with a authorized servicing dealer. Impeller blades are missing or damaged. Heat sensor is activated, due to restricted air flow at intake cover. Stop the engine. Clean debris blocking intake cover. Restart. Idle more than 1 minute. If engine speed is reduced again, consult with an authorized servicing dealer. Engine speed is reduced. 19 The following statement only applies to United States and its territories Shindaiwa Corporation Federal Emission Design And Defect Limited Warranty Utility And Lawn And Garden Engines Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission warranty is applicable in all States, except the State of California. For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the necessary diagnosis, repair, or replacement of any defective emission-related component to ensure that the engine complies with applicable U.S. EPA regulations. MANUFACTURERS WARRANTY COVERAGE When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser. OWNER’S WARRANTY RESPONSIBILITIES As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corporation recommends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications. You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists. If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time. PARTS COVERED Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement of that part. The warranted parts include: 1. Carburetor Internal Components • Valve Assembly-throttle, Jet, Metering Diaphragm 2. Ignition System Components • Ignition Coil • Flywheel Rotor The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors. LIMITATIONS The Fede...
Эта инструкция также подходит к моделям:Системы вентиляции - EB802 (3.76 mb)
Системы вентиляции - EB802RT (3.76 mb)