Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
2-CYCLE FUEL / OIL MIX (50:1) GASOLINE OIL 1 gallon (US) 2.6 oz. 1 liter 20 cc (20 ml) HOT RESTART OF THE ENGINE: . Set the choke lever to the RUN position. . Lock throttle/cruise control lever. . Pull the starter grip and rope until the engine runs. IF ASSISTANCE IS REQUIRED STARTING THIS PRODUCT: Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have. For Help Call: 1-800-860-4050 OPERATING THE BLOWER See Figures 9 - 10. WARNING: Never run the unit without the blower tubes installed or the vacuum door securely closed. Use of an improperly assembled unit could result in serious personal injury. . Start the blower. Refer to Starting and Stopping earlier in this manual. Hold the blower with the upper handle in your right hand. WARNING: Always hold the blower away from your body with the handle in your right hand when operating as a blower, keeping clearance between your body and the product. The muffler side of the blower should be away from your body. Any contact with the housing can result in burns and/or other serious personal injury. WARNING: Do not place blower on top of or near loose debris or gravel. Debris may be sucked into blower intake vent resulting in possible damage to the unit and could result in serious personal injury. . To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile. . Operate power equipment at reasonable hours only - not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordinances. . To reduce sound levels, limit the number of pieces of equipment used at any one time. . Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens. . Operate blower at the lowest possible throttle speed to do the job. . Check your equipment before operation, especially the muffler, air intakes, and air filters. . Use rakes and brooms to loosen debris before blowing. . In dusty conditions, slightly dampen surfaces when water is available. . Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away. . Hold blower, as shown in Figure 9, so the air stream can work close to the ground. . After using blowers or other equipment, CLEAN UP! Dispose of debris properly. . Use the sweeper nozzle for the everyday blowing operation. This nozzle allows for more area to be covered during the blowing operation. CRUISE CONTROL See Figure 11. The cruise control can be used to operate the blower without holding the throttle trigger. To engage the cruise control: . Pull cruise control lever back towards user, and stop at the desired throttle setting. . To release the cruise control, push cruise control lever all the way towards the front of unit. VACUUM OPERATION See Figure 12. WARNING: Never run the unit without the vacuum tubes and vacuum bag installed. Use of an improperly assembled unit could result in serious personal injury. WARNING: Keep the muffler and all hot surfaces of the blower/ vacuum away from your body. Failure to do so could result in possible serious personal injury. . Install the vacuum tubes and the bag. Refer to the ASSEMBLY section earlier in this manual. . Start the blower. Refer to Starting and Stopping earlier in this manual. . Place the vacuum bag strap over your right shoulder. Hold the upper handle in your left hand and the vacuum handle in your right hand. . Move the blower/vacuum from side to side along outer edge of the debris. To avoid clogging, do not place the vacuum tube directly into the debris pile. OPERATION . Hold the engine higher than the inlet end of the vacuum tube. . Always point vacuum tube downhill when working on a hillside. . To avoid serious injury to the operator or damage to the unit, do not pick up rocks, metal, broken glass, bottles, or other similar objects. . If the vacuum tubes should clog, stop the engine , ensure impeller blades have stopped spinning, and disconnect the spark plug wire before cleaning out the obstruction. . Remove the vacuum tubes and clear the debris from the blower fan housing. Remove the bag and clear the tube. A small rod or stick may be required to clear the entire tube length. Ensure that all debris has been cleared before reassembling the vacuum tubes. OPERATION MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: Before inspecting, cleaning, or servicing the machine, shut off engine, wait for all moving parts to stop, and disconnect spark plug wire and move it aw...