5. Lift the handle from the cartridge. 2.5 mm [1/8”] key 6. Find the small notch at the base of the chrome ring cap and carefully pry up against this to remove the cap. 28 mm [1-1/8”] key 7. Remove the brass retaining ring. 8. Lift out the cartridge. 9. Ensure that the seats and O-rings are in good condition. 10. Remove potential mineral deposits from inside the faucet body. 11. Install the new cartridge so that the central pivots fit into the corresponding seats. 12. Re-assemble faucet in rever

If the bag full control light 2 is on, the shredded material can be further compacted. To further compact the shreds, open the cabinet door and step hard to the compacting pedal G a few times. Now more material can be shredded until the machine stops again („Bag full“ indicator). Again operate the compacting pedal as described above and then remove the shred bag (Plastic bags are available from the manufacturer - see accessories). By extreme overloading the motor protection switch F will cut off

Grune Kontrolleuchte 1 leuchtet auf. Der Aktenvernichter ist nun betriebsbereit (Stand-by-Modus). Bei Papierzufuhrung startet die Maschine automatisch und schaltet nach dem Vernichtungsvorgang auch automatisch wieder ab. Leuchtet die Sack-voll-Anzeige 2, kann das vernichtete Material noch kompaktiert werden. Dazu Tur des Unterschranks offnen und einige Male auf das Kompaktierungspedal G treten. Nun kann weitervernichtet werden, bis die Maschine erneut abschaltet (Sack-voll-Anzeige). Wieder das K

11.Do not attempt to service this product yourself, as opening or removing covers may exposeyou to dangerous live parts or other risks. 12.Unplug this product and refer servicing toqualified personnel under the followingconditions: A)When the power cord or plug is damaged orfrayed. B)If liquid has been spilled on the product. C)If the product has been exposed to rain. D)If the product does not operate normally whenthe operating instructions are followed. E)If the product has been dropped or the

To ensure sufficientventilation of the shredder a minimum distanceof 4" (10 cm) to the wall or to thefurniture mustbe maintained. 6.CautionNever insert hand, fingers or anyforeign objects into the feedopening. Serious injury may result. Keep all loose articles ofclothing, ties, jewelery, long hairor other loose objects away fromfeed opening. Injury may result. Always turn off and unplug themachine before moving, servicing, cleaning or any otherconduct other than normaloperation. Serious injury m

3.Follow all warnings and instructions marked onthe product. 4.Unplug this product from the wall outlet beforecleaning. Clean with a damp cloth using a mildsoap and water solution. (Do not use abrasivesor petroleum based cleaners.) 5.Place this product as close as possible topower source for quick and easy unplugging. 6.Do not use this product near water. 7.This product should never be placed near orover a radiator or heat source. 8.Operate from the type power source indicatedon the marking labe

CAUTION: The shredder may be damaged if you alternate too rapidly between forward and reverse. • Unplug shredder and remove wastebasket drawer (A). – Carefully clear any paper shreds that have collected on under side of paper entry (C). CAUTION: Model 120C-2 (confetti cut model) has exposed blades.Use care when removing paper shreds on underside of paper entry. To clear a paper jam If paper jam light (J) is on, follow these steps until light turns off. • Check the waste basket and empty if full.

We have made many improvements in our commercial shredder since its introduction in 1982. We are confident that it offers you the greatest value for your money in its product category today. We hope it meets – or even exceeds – your expectations. To ensure years of safe, efficient use, please read these few pages about your new shredder. If this manual doesn’t answer all your questions or if you wish to comment on this product, we welcome your call or letter. Sincerely, James Fellowes Chairman &

-Press the oilpump button 3 x. -After lubrication let the machine run several times backwards and forwards alternately. -If tank (8) is empty refill with oil. Type of oil: cutting head oil 3.6 Replacing the plastic bag (IDEAL 4107) Replace bag when “bag full“ indicator lights. -Open the door (9). -Pull out the plastic bag holding the bottom of the bag. -Push down the waste paper. -Pull out the waste bag with frame (10) until it stops. -Remove the round belt (11) from the waste bag frame. -Tie th