Read and understand this entire manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they become obscured or removed. 4. This sander is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a sander, do not use until proper training

To obtain maximum life and efficiency from your Drum Sander and to aid in using it safely, please read this manual thoroughly and follow instructions carefully. Warranty & Service WMH Tool Group warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Repair Stations located throughout the United States can provide quick service or information. In most cases, a WMH Tool Group Repair Station can assist in authorizing repair work, obtaining parts, or perf

Try to avoid over- adjustments. Conveyor Belt Replacement 1. To replace a worn conveyor belt, raise drum to highest position. Unplug machine from power source and unplug motor cord from control box receptacle. 2. Adjust conveyor take-up screw nuts (Figure 22) to relieve belt tension. Figure 21 (repeated) Figure 22 16 3. Remove the four bolts attaching conveyor assembly to base. Lift up and slide conveyor out to the side of the machine. 4. Set conveyor on motor side and slide conveyor belt off th

Hold the cleaning stick against the rotating drum and move it along the drum surface. It is good idea to use a shop brush or air nozzle to remove any cleaning stick crumbs from the drums before resuming sanding operations. Cloth-backed abrasives can be cleaned by soaking in paint thinner, or mineral spirits for 20 minutes to one hour. Then use a nylon brush to remove any buildup. Stretching Abrasive Life Abrasive life can also be increased by removing the abrasive strip from the drum and reversi

See Detail 1 below. 3. Turn stand upside down. Install shelf (J) into legs (H) using carriage bolts and lock nuts. 4. Fully tighten all flanged lock nuts in shelf and legs. 5. If you are using the provided leveling foot (M), place it in bottom hole of leg by placing a hex nut (P) and flat washer (R) above and below the leg flange. If you are mounting the optional casters, see “Casters” below. 6. Turn stand right-side up, and level it using the leveling feet. Tighten the leveling feet hex nuts ag

If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these WMH Tool Group Authorized Service Centers can authorize warranty repair, assist you in obtaining parts, or perform routine maintenance and major repair on your JET® tools. For the name of an Authorized Service Center in your area call 1-800-274-6848. MORE INFORMATION WMH Tool Group is consistently adding new products to th

Its purpose, aside from machine operation, is to promote safety through the use of accepted correct operating and maintenance procedures. Completely read the safety and maintenance instructions before operating or servicing the machine. To obtain maximum life and efficiency from your Sander, and to aid in using the machine safely, read this manual thoroughly and follow instructions carefully. Warranty & Service The JET Group warrants every product it sells. If one of our tools needs service or r