Оценок - , средний балл: ( )

Инструкция по эксплуатации American Standard, модель 403

Производитель: American Standard
Размер: 226.72 kb
Название файла:

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Various pedestal screw sizes and types are available to the installer at local hardware outlets. 1-A Provide suitable reinforcement behind finished wall for lavatory mounting screws. * Determine horizontal center line location of support from fixture. NOTE: If replacing an existing sink be certain to shut off water supply before removing old sink. C/L of 2X6 Support Finished Floor * 1-C Mark lavatory and pedestal screw locations through the mounting holes. 1-B Top of Pedestal For example only Place lavatory and pedestal into installed position. Level and square the lavatory and pedestal assembly. Use one or more bumper cushions to level and cushion lavatory slab to pedestal. 1-H Secure lavatory to wall as shown in 1E. Install washers and hand tighten nuts or lag bolts. Level and square the unit. Connect hot and cold supply lines to the shut-off valves. Tighten trap joints for watertight assembly. Following manufacturer's instructions, install faucet and drain assembly (not included). Be certain to apply a bead of sealing putty on the underside of the drain (area "A") in order to ensure a watertight seal between the lavatory and drain. Remove excess putty after installing drain on lavatory. Return the fitted lavatory to the installed position. Connect trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg of the trap (area "C"). Approx. Bumper locations to raise the lavatory slab left side. Install lavatory anchor screws leaving 1-7/8" threaded end exposed as illustrated. 7301354-100 Rev. B 2 A 2. Wall-hung on furniture 2-A 2-E 2-B 2-C 2-D Mounting on Furniture: Assemble vanity as per instructions. Mount the faucet and drain assembly (not included) on the sink following the manufacturer’s instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part “A”) in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink. 2-F A Vanity Installation: • Place the sink temporarily on the vanity to check for alignment and clearance 2-G After checking fit and alignment, turn sink upside down and apply a generous portion of silicone adhesive around the under side of the rim near the edge. Place sink in position. Wipe off excess adhesive. Use the mounting holes on the rear of the lavatory to secure the sink to the wall. Shut-Off Valves Connect supply line to faucet (finger tight) and carefully bend tubes to engage with the supply shut-off valves. Tighten connections at faucet and shut-off valves for secure seal. B C Connect trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area “B”) or part of the horizontal leg of the trap (area “C”). Secure joints for watertight assembly. 7301354-100 Rev. B 3 3. Above Counter OR 4. Drop-in ** BACK OF LAVATORY IS UNGLAZED ** The lavatory must be installed flush with wall. Countertop Installatio...