Войти:
Оценок - 4, средний балл: 4.3 ( )

Инструкция по эксплуатации Delta, модель STUDIO 621.001

Производитель: Delta
Размер: 115.15 kb
Название файла: Install_2143.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Provide proper clearance under the countertop for the faucet supply lines, drain assembly and the structural parts of the cabinet. NOTE: If replacing an existing sink be certain to shut off water supply before removing old sink. Drill a clearance hole inside the perimeter line of the template for countertop installation. Cut opening around the perimeter of the template Mount the faucet and drain assembly (not included) on the sink following the manufacturer’s instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part “A”) in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink. ÏT Check for alignment and clearance. Mark the sink and countertop in several places as a guide for the installation location. After checking fit and alignment, turn sink upside down and apply a generous portion of silicone adhesive around the under side of the rim near the edge. Place sink in position. Wipe off excess adhesive. Mounting holes are provided on the rear of the lavatory so it can be secured to the wall if desired. Connect supply line to faucet (finger tight) and carefully bend tubes to engage with the supply shut-off valves. Tighten connections at faucet and shut-off valves for secure seal. Connect trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area “B”) or part of the horizontal leg of the trap (area “C”). Secure joints for watertight assembly. 1 5 2 6 3 8 Product names listed herein are trademarks of AS America, Inc © AS America, Inc. 2009 7301244-100 Rev. A SAVE FOR FUTURE USE VANITY INSTALLATION Assemble vanity as per instructions. Mounting holes are provided on the rear of the lavatory so it can be secured to the wall if desired. Mount the faucet and drain assembly (not included) on the sink following the manufacturer’s instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part “A”) in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink. Connect supply line to faucet (finger tight) and carefully bend tubes to engage with the supply shut-off valves. Tighten connections at faucet and shut-off valves for secure seal. » Place the sink on the vanity to check for alignment and clearance. » The sink should be centered left to right on the vanity with the front edge of the sink even with the front of the vanity. » Secure sink to furniture as per vanity instructions. Connect trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area “B”) or part of the horizontal leg of the trap (area “C”). Secure joints for watertight assembly. 1 2 6 3 REPAIR PART NO. DESCRIPTION 738990-0020A CHROME OVERFLOW CAP 2 7301244-100 Rev. A...

Эта инструкция также подходит к моделям:
Сантехника - STUDIO 621.001 (115.15 kb)
Сантехника - STUDIO 621.001 (115.15 kb)
Сантехника - STUDIO 621.001 (115.15 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории