Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
311-134M Before You Start Assembly Instructions ft When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it! IMPORTANT: Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information. Your Down Pressure Kit is exclusively designed for your Land Pride Rotary Tiller. Please read these installation instructions and your Rotary Tiller Operator’s Manual thoroughly before beginning. Especially read information relating to safety concerns. Also included in the Operator’s Manual is important information on operation, adjustment, troubleshooting, and maintenance for this attachment (some manual sections do not apply to all accessories). A separate Parts Manual for replacement parts can be purchased from your dealer or available free of charge at Have model and serial numbers handy when placing an order. Manual Part Numbers: • RTA25 Series Operator’s Manual . . . . 311-254M • RTA 35 Series Operator’s Manual..... 311-254M • RTR 25 Series Operator’s Manual ..... 311-251M • Parts Manual (All Three Series)........311-251P General Information This assembly instructions apply to the following Down Pressure Kit listed below: 311-162 A Down Pressure Kit A detailed listing of parts for this accessory kit is provided below. Use the list as a checklist to inventory parts received. Please contact your local Land Pride dealer for any missing hardware. Tools required: • Safety glasses • Work gloves • 9/16" box end or open end wrench Refer to Figure 1: 1. Remove wire lock pin (#5). 2. Rotate bottom of spring rod (#1) back. 3. Slide down pressure spring (#2) up the spring rod. 4. Slide locking collar (#3) up spring rod and lightly tighten 3/8" x 3/4" long bolt (#4). 5. Rotate spring rod back to mounting ears on rear deflector and reinstall wire lock pin. 6. Repeat steps 1 through 5 for other spring rod. 7. Adjust lock collars up or down to achieve desired amount of down pressure on the rear deflector. NOTE: The lock collars should be the same height. NOTE: Too much pressure will cause premature wear on the underneath side of the rear deflector. Down Pressure Kit Assembly Figure 1 © Copyright 2007 Printed 5/15/07 1 Corporate Office: P.O. Box 5060 Salina, Kansas 67402-5060 USA www.landpride.com...