Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
• Do not smoke or take sources of heat or sparks near the fuel. • Refuel with the engine off. • Open the cap on the tank carefully to eliminate any excess pressure. • Do not take the cap off the tank with the engine running. • After fueling, close the cap tightly. • Fill the tank in a well-ventilated place. • Place the machine on a solid flat surface so that it cannot tip over, with the cap on the tank facing upward. ENGLISH - 4 • Clean the area around the fuel cap before removing it, to prevent any impurities from contaminating the fuel. • Take the cap off the fuel container carefully. Unscrew the cap on the fuel tank and fill it with the necessary quality, using a funnel. • Take care not to spill any fuel. • After filling the tank, screw the cap on tightly. CAUTION! If you spill any fuel, wipe it off the machine. If you have spilt it on yourself, change your clothes at once. Avoid contact with the skin or eyes. CAUTION! The muffler gets very hot dur ing use and remains hot for some time after switching off the engine. This also applies at idle speed. Take every precaution to reduce the fire hazard, especially in the presence of inflammable materials or gas. FUEL STORAGE • Gasoline is highly inflammable. • Before going near any type of fuel, put out your cigarette, pipe or cigar. • Store the fuel in a cool, well-ventilated place, in an approved fuel storage container. • Never store the engine with fuel in the tank in a poorly ventilated place where the fumes produced by the gasoline could propagate and reach a fire, candle, burner or furnace pilot light, water heater, dryer, etc. • The fumes produced by the fuel can cause an explosion or fire. • Never store excessive quantities of fuel. • To prevent problems in starting the engine again, we recommend that you never let the machine run completely out of fuel. E. Cutting procedure any reason without the certainty that the accidents. height. down. release knob (E), has returned to its original position with the grip correctly locked. CAUTION! Before using the machine, make sure the rear grip is firmly locked in one of the proper positions so as to prevent CAUTION! If the grip does not remain locked in one of the three positions, take the machine to an Authorized Service Center. The horizontal cutting position is used to even the tops of bushes, shrubs and hedges. • Always cut from right to left. • Never use the hedge trimmer above shoulder The vertical cutting procedure is used to trim the sides of shrubs, bushes and hedges. • Always cut upward from the bottom. • Hold the machine with both hands. ess the trigger of the butterfly valve all the way during cutting operations. • When you have finished, release the trigger on the butterfly valve and wait for the engine to idle; the blade should stop. • Move on to the next section. • After reaching the next section and taking a stable standing position, resume working by pressing the trigger on the butterfly valve all the way ENGLISH - 5 F. Starting and ...
Эта инструкция также подходит к моделям:Садовые инструменты - HANDLEIDING HG 50 TIVTIVOLI 63 (1.2 mb)
Садовые инструменты - HANDLEIDING HG 50OLI 50 (1.2 mb)
Садовые инструменты - HANDLEIDING HG 63 TIVTIVOLI 65 (1.2 mb)
Садовые инструменты - HANDLEIDING HG 63OLI 63 (1.2 mb)