Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Always wear sturdy shoes and avoid wearing bulky or loose clothing while operating equipment. Never operate equipment when tired or while under the influence of drugs or alcohol. In case of emergency, know how to stop the equipment and thoroughly understand the. operation of ALL controls. Never permit anyone to operate equipment without proper instructions. Children'should not be permitted to operate the tractor or rotary tiller. KEEP CHILDREN AND PETS AT A SAFE DISTANCE DURING OPERATION. The tractor is an operator only vehicle, do not allow passengers to ride on the tractor or the rotary tiller. TRACTOR PREPARATION GENERAL TILLER SAFETY Operation of the Rotary Tiller requires special efforts on your part to ensure your safety and the safety of others. Know these requirements before you operate the Rotary Tiller. 0 To avoid injury or tiller damage, do not allow anyone to stand on or ride on the tiller. To avoid injury from rotating parts or thrown objects, do not stand or allow others to stand near the tiller while it is operating. Clear the area of all debris before beginning tiller operation. 0 Operating the tiller in the fully raised position may exceed the maximum angle of the driveline. To avoid tiller damage and possible loss of control, do not add weight to the top of the tiller. To avoid injury to yourself and others; do not leave the tiller in the raised position when unattended. KEEP CHILDREN AND PETS AT A SAFE DISTANCE WHEN OPERATING THE ROTARY TILLER. Never wear loose clothing when operating the rotary tiller. Loose clothing may become entangled in rotating parts or become hooked on controls leading to injury or damage to property. Never leave the tractor operator's seat when the tractor is in motion; or while the Power Take Off (PTO) is engaged. Before getting off the tractor, always: -shut the engine off -remove the ignition key -wait for the PTO to stop turning -then lower the tiller to the ground To avoid personal injury or equipment damage, never attempt to clean or adjust the tiller with the tractor engine running. HITCH Operation of the TL 5040 Rotary Tiller requires the optional rear hydraulic lift and three point hitch be installed on the tractor. FRONT COUNTERWEIGHT Proper operation of the Rotary Tiller requires the installation of an optional front counterweight bracket and four 26 pound (11,8 Kg.) weights. The addition of the front counter weight may not always maintain satisfactory stability. Reduce tractor speed and exercise caution under these conditions to prevent severe personal injury or property damage. I I Do not exceed weight limitations stated in the tractor owner's manual or equipment damage may result. TIRE PRESSURE Proper tractor tire pressure with tiller and front weight kit installed: Front Rear Turf tires Agricultural tires 14 psi20 psi 11 psi24 psi MAINTENANCE SAFETY Before performing maintenance /inspection, read the instructions thoroughIy. 0 Before cleaning inspecting or sevicing the tiller or the tractor be sure to: -move the Power Take Off (PTO) Iever to the "OFF"position. -lower the tiller to the ground. -stop the engine and remove the key. 0 If you strike an object while driving or tilling, stop the engine and inspect the tractor and the tiIler. Repair any damage before you resume operation. 0 Operating the tiller or the tractor with damaged, worn or broken parts may result in severe personal injury. 0 All nuts, bolts and fasteners must be tight. SAFETYLABELS Danger Label location on driveline I SHIELD MISSING I DO NOT OPERATE Fig. 1 ROTATING DRIVELINE conTAcT cAn CAUSE own KEEP AWAY! DO NOT OPERATE WITHOUT- * ALL DRIVELINE TRACTOR AND EQUIPMENT SHIELDS IN PUCE DRIVELINES SECURELY ATTACHED AT BOTH ENDS DRIVELINE SHIELDS TnAT Turin FREELV.ON DRIVELINE Fig.2 2 15 4 KEEP AWAY FROM ROTATING TINES Rotating tines will cause injury Fig. 1 Fig.4 Fill Gearbox with oil before Universal joints can be damaged Il lift each use to prevent gearbox angle is excessive and PTO is engaged. damage. Using a high-speed PTO to drive this Adjust tractor lift linkage or hydraulic implement can cause severe damage and could seriously injure anyone nearby. MAXIMUM PTO SPEED: 2000 RPM Fig.2 Fig.5 Fig. 6 (501 mm) hltch pln bracket Fig. 6 n Fig. 3 I-=-””” DEALER ASSEMBLY INSTRUCTIONS 1 Install female end of driveline onto Tiller gearbox input shaft and secure with proper quick locking device Fig. 3. 2 Attach three point hitch mast struts and driveline shield to tiller frame using M12x30 mm. bolts, lock washers and nuts Fig.2. 3 Attach mast braces to mast struts using a M12x90mm bolt, spacer, nut and jam nut Fig. 4. 4 Secure mast brackets onto clamps on gearbox housing using a M12x80mm spacer, nut and jam nut. 5 Install hitch.pin brackets onto frame using two M12x9Omm bolts, with lock washers. Fig. 5 Brackets must be installed with the weld nut on top side maintaining a distance of 19-3/4” (501 mm) centered between brackets. Fig. 6. 6 Check gearbox oil level per instructions in LUBRICATION ...