Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
3. Turn the module gain pot down counter clockwise (Left direction). 4. Turn EQ pot clockwise (Right direction). 5. Turn the AA120M power switch off. 6. Carefully inset the AA-SMG module into the card guider rails. Push until card is seated and the panels are flush. Secure with screws. 7. Select the AA120M input module mode, switch #5 located on the rear panel of the amp. 8. Turn all levels down on amplifier. Note if the module is in Amp Direct mode, the only level control you have for masking is the Gain pot on the AA-SMG. The Master and Input 6 levels on the AA120M are bypassed. All other channels operate normally. 9. Turn the amp on. You should be hearing either White or Pink noise. 10. Whenever connecting the Line Out or Insert jack, always turn off the AA120M prior to connection. 11. Tune the system as needed. Always a good suggestion to refer to Atlas’s white paper on masking. TIP SLEEVE (SEND) (GND) (GND) RING (REC) TIP (HOT) CONNECT TO AA-SMG SLEEVE TIP (GND) (SEND) SEND - CONNECT TO EQ IN SLEEVE TIP (GND) (REC) RECEIVE - CONNECT TO EQ OUT Specifications are subject to change without noticeAtlasSound.com 1601 JACK MCKAYBOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435 ©2007 ATLAS SOUND LPPrinted in U.S.A. ATS002745 RevA3/07 2 INSTALLATION INSTRUCTIONS AA-SMGSOUNDMASKINGMODULEAA-SMGSOUNDMASKINGMODULE GRAPH #1 #1 AA-SMG – This graph illustrates the comparison of the Line Out White Noise vs. Pink Noise with no EQ by passed. GRAPH #2 #2 This graph shows the 70v tap output waveform of the AA-SMG in White Noise mode. The graph comparison is indicating the EQ trim engaged (Counterclockwise) or disengaged (Clockwise). Note: This graph also indicates the bandwidth of the AA120M amplifier and 70v transformer. Specifications are subject to change without noticeAtlasSound.com 1601 JACK MCKAYBOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435 ©2007 ATLAS SOUND LPPrinted in U.S.A. ATS002745 RevA3/07 3 INSTALLATION INSTRUCTIONS AA-SMGSOUNDMASKINGMODULEAA-SMGSOUNDMASKINGMODULE GRAPH #3 #3 This graph shows the 70v tap output waveform of the AA-SMG in Pink Noise mode. The graph comparison is indicating the EQ trim engaged (Counterclockwise) or disengaged (Clockwise). Note: This graph also indicates the bandwidth of the AA120M amplifier and 70v transformer. AA-SMG SPECIFICATIONS: Filter Selection: White, Pink Noise Gain Controls: 70v output AA120, 1v minimum – 30v maximum Input Connection: EQ insert via TRS 1.4” jack. Line Output: RCA Unbalanced, Pre EQ fixed 300mV, Post EQ variable 60mv – 1.4V EQ Control: Variable Low Cut 1KHz – 7KHZ, defeatable on Line Out Supply Voltage: 24 VDC, 30 mA internally derived from AA120M amplifier Panel Finish: Silver Dimensions: 1.38” W., x 3” H. x 3” D. (35X78X78 mm) Specifications are subject to change without noticeAtlasSound.com 1601 JACK MCKAYBOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435 ©2007 ATLAS SOUND LPPrinted in U.S.A. ATS002745 RevA3/07 4 ...
Эта инструкция также подходит к моделям:Ресиверы и усилители - Sound Masking Module AA-SMG (155.29 kb)