Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
3 Rotate the jog dial until “On” appears in the display, and then press ENTER. To turn off the i.LINK Control function Do the procedure above, selecting “Off” in step 3. Notes • The i.LINK Control functions described above may not work properly on certain components and under certain conditions. • Make sure i.LINK Control is active on only one component within the i.LINK configuration. For example, when two STRLSA1s are hooked up in the same configuration, turn on the i.LINK Control function on only one receiver and not the other. 24GB Other Settings Using the Setup Menu Verifying which component is currently selected (Ping function) When the Ping function is turned on, you can verify which of the components is currently selected by pressing the DISPLAY button on the receiver. An indication momentarily appears in the display of the currently selected component. The indication varies depending on the component. For example, if the selected component is either the CDP-LSA1 or the MDS-LSA1, “N N n n” appears in the display of the component. Note that this function works on Sony i.LINK MD deck and CD player only. 1 Press JOG MENU repeatedly until “Setup Menu” appears in the display. 2 Rotate the jog dial until “Ping” appears in the display, and then press ENTER. 3 Rotate the jog dial until “On” appears in the display, and then press ENTER. To turn off the Ping function Do the procedure above, selecting “Off” in step 3. Improving the quality of the audio signal (H.A.T.S. function) When the H.A.T.S. function is turned on, digital audio signals are momentarily stored in a buffer prior to output. This reduces the jitter that sometimes occurs during digital transmission. When this function is turned on, the H.A.T.S. indicator on the front panel lights up whenever the digital audio signal is input to the receiver. 1 Press JOG MENU repeatedly until “Setup Menu” appears in the display. 2 Rotate the jog dial until “H.A.T.S.” appears in the display, and then press ENTER. 3 Rotate the jog dial until “On” appears in the display, and then press ENTER. To turn off the H.A.T.S. function Do the procedure above, selecting “Off” in step 3. Notes • Due to the operating principle of the H.A.T.S. function, a slight time lag is introduced between the initiation of an operation (e.g., pressing the play button, stop button, or pause button) and the actual audio output. • The H.A.T.S. function is effective only for the components supporting this function. • On this receiver, the H.A.T.S. function works only with digital audio signals with a sampling frequency of 44.1 kHz. • The H.A.T.S. function does not work when the program source component selected by the receiver is also selected by another component (e.g., another receiver or the MD deck). This is because the receiver controls the transmission rate of the digital audio signals output from the program source component, and for proper signal transmissi...