Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Before you perform the Auto Calibration 1 Install and connect the speakers and TV. For details, see front page. 2 Connect the supplied optimizer microphone to the AUTO CAL MIC jack. The AUTO CAL MIC jack is used for the supplied optimizer microphone only. Do not connect other microphones. Doing so may damage the receiver and the microphone. 3 Set up the optimizer microphone. Place the optimizer microphone at your listening position. Use a stool or tripod so that the optimizer microphone remains at the same height as your ears. On setting up the active subwoofer When a subwoofer is connected, turn on the subwoofer and turn up the volume beforehand. Turn the MASTER VOLUME to just before the mid-point. If you connect a subwoofer with the crossover frequency function, set the value to maximum. If you connect a subwoofer with an auto standby function, set it to off (deactivated). Performing Auto Calibration The Auto Calibration function allows you to measure the following: speaker connections, polarity of speakers, speaker distance, speaker size, speaker level, frequency characteristics. 1 Connect a TV to this receiver. Refer to “Connecting the TV” in the operating instructions. 2 Turn on the TV. 3 Press ./. to turn on the receiver. Switch the input of the TV so that an image of the menu is displayed. 4 Press GUI MODE. After “MENU ON” appears on the display for a while, “GUI” appears and the GUI menu appears on the TV screen. Press MENU if the menu list does not appear on the TV screen. 5 Press ./. repeatedly to select “Settings”, then press or .. The Settings menu list appears on the TV screen. 6 Press ./. repeatedly to select “Auto Cal.”, then press or .. 7 Press ./. repeatedly to select “Auto Cal. Start”, then press or .. 8 Press to select “START”. 9 The measurement starts in 5 seconds. 10 Measurement starts. The measurement process will take approximately 30 seconds with a test tone. Wait until the measurement process completes. . . . 11 The measurement is completed. When the measurement ends, a beep sounds. 12 Press ./. repeatedly to select “Save”, then press . The measurement results are saved. 13 Press ./. repeatedly to select the Auto Calibration Type, then press . Calibration type and explanation Full Flat Makes the measurement of frequency from each speaker flat. EngineerSets the frequency to one that matches that of the Sony listening room standard. Front Reference Adjusts the characteristics of all the speakers to match the characteristics of the front speaker. Off Sets the Auto Calibration to off. When error codes appear For details on warning and error codes, see “Message list after Auto Calibration measurement” in “Calibrating the appropriate speaker settings automatically (Auto Calibration)” in the operating instructions. Tip The size of a speaker (“Large”/“Small”) is determined by the low frequency ch...