Оценок - 2, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Connect the lead (black) to the [ANTENNA M] terminal. The [ANTENNA M] terminal is exclusively for the antenna. It is not an earth terminal for safety purpose. .. For more information, see “Connecting Other Accessories (Commercially Available Units)” on P.13–15. AC power cord Insert the plug fi rmly all the way into the AC wall outlet. .. 10 R-K1000 Connecting the System Microcomputer malfunctions If the system is connected correctly and still does not operate normally or shows display errors, reset the microcomputer. (P.65) Connecting the AM loop antenna 1 The antenna supplied with the system is for indoor use. Place it as far as possible away from the main unit, your TV set, the speaker cords and the power cord and point it in the direction that gives the best reception. • Connecting the antenna cord Place the AM antenna cord as shown on the right and connect the lead (red) to the right side of the [AM] terminal and the lead (white) to the left side. 123 Connecting the FM indoor antenna 2 The antenna supplied with the system is a basic antenna for indoor use. For stable signal reception, the use of an outdoor antenna (commercially available unit) is recommended. To connect an outdoor antenna, fi rst remove the indoor antenna. Connecting the speakers 3 Notes on connecting the speaker cords Never short-circuit the positive (+) and negative (–) ends of the speaker cords. (Do not touch the + and – cords together.) Mistakenly reversing the positive and negative polarity will result in unnatural sound and unclear sound source (e.g. musical instruments) locations. • Preparing the ends of the speaker cords Twist the plastic sleeve on the end of the cord as you pull it off . • Connecting the speaker cords 1234 Twist and remove Loosen the knob Insert the cord Tighten the knob English 11 Connecting the System Connecting the System Connecting the CD Player (DP-K1000 – sold separately) • When connecting a CD player, read the instruction manual for the DP-K1000 also. • Ensure that all the cords are securely connected. Loose or incomplete connections may result in noise interference or no sound at all. To AC wall outlet AC power cord Insert the plug firmly all the way into the AC wall outlet. .. DP-K1000 12 CD IN (COAX) 1 To AC wall outlet Use the coaxial cable supplied with the DP-K1000 to connect the [DIGITAL OUT COAXIAL] terminal on the DP-K1000 to the [CD IN (COAX)] terminal on the rear panel of the R-K1000. SYSTEM CONTROL 2 Use the system control cable supplied with the DP-K1000 to connect the [SYSTEM CONTROL] terminal on the DP-K1000 to the [SYSTEM CONTROL] terminal on the rear panel of the R-K1000. • To connect a CD player other than the DP-K1000 to the R-K1000, use an analog connection to connect the audio output terminal on the CD player to the [AUX IN] terminal on the rear panel of the R-K1000. When using a digital connection, connect the optical digital output terminal on the CD player to the [DIGITAL IN 1 (OPT)] or [DIGIT...
Эта инструкция также подходит к моделям:Автоусилители - AMPLIFIER/TUNER R-K1000 (2.4 mb)