Оценок - 2, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
3 PREPARATION Replace the battery cover. 3 PREPARATION 1 Remove the battery cover on the back of the remote by pressing down and sliding the cover in the direction of the arrow. 2 Insert two 1.5V AAA batteries, paying attention to the correct polarities (+ and –). Caution ! Follow these precautions to avoid leaking or cracking batteries: • Place batteries in the remote control so they match the polarity:(+) to (+)and (–)to (–). • Use the correct type of batteries.Batteries that look similar may differ in voltage. • Always replace both batteries at the same time. • Do not expose batteries to heat or flame. 8 To open the remote control cover, push the top of the cover, then slide downward. The remote control can be used up to approximately 23 feet/7 meters in a straight line. It can also be operated at a horizontal angle of up to 30° from the remote control sensor. Range of Operation of the Remote Control Connecting the Speakers Before moving or installing the product, be sure to turn off the power and disconnect the power cord. SL SR SB Connecting the Speakers Before moving or installing the product, be sure to turn off the power and disconnect the power cord. SL SR SB Position of AV Receiver • Place AV Receiver on the dedicated stand or chest of living room or under the TV stand properly. Front Speakers • Adjust the angle of front left and right speakers so that it can form 30 degree to the left and right from the listening position. • Place the speakers so that their tweeters will be at the same height as your ear. • Align the front face of the front speakers with the front face of the center speaker or place them slightly in front of the center speaker. Center Speaker • It is best to install center speaker at the same height as the front speakers. • You can also place center speaker directly over or under the TV. Subwoofer • The position of the subwoofer is not so critical. Place it anywhere you like. • Usually, it is placed by a corner near the front speakers. Rear Speakers • Place the rear left and right speaker at the interval of front left and right speaker. • If there isn't enough now, place rear speakers to face down other. • Place the rear speakers about 70 cm to 1 m above your ear, facing slightly downwards. . Unlike the front and center speakers, the rear speakers and used to mainly sound effects and sound will not come from them all the time. Rear Center Speaker • If you place 1 rear center speaker, place it so that it faces forward from the back of listener. • Place the rear center speaker about 70 cm to 1 m above rear speakers, facing slightly downwards. Caution! When you place the speaker on the wall, make sure to fasten it tightly so that it may not fall off. v Connecting Front Speaker Wire SYSTEM MODEL NAME : HT-AS700 PASSIVE SUBWOOFER ACTIVE SUBWOOFER (BUILT-IN POWER AMPLIFIER) PSAW700E POWER AMPLIFIER PSAF700E PSAF700E PSAR700E PSAR700E MAIN UNIT AV-R700 CENTER PSAC700E REAR CENTER PSAB700E v Connecting Front Speaker Wire SYSTEM MODEL NAME : HT-AS700 PASSIVE SUBWOOFER ACTIVE SUBWOOFER (BUILT-IN POWER AMPLIFIER) PSAW700E POWER AMPLIFIER PSAF700E PSAF700E PSAR700E PSAR700E MAIN UNIT AV-R700 CENTER PSAC700E REAR CENTER PSAB700E FRONT (R) FRONT (L) REAR (R) REAR (L) MAIN UNIT AV-R700 FRONT SPEAKER PSAF700E CENTER SPEAKER PSAC700E REAR SPEAKER PSAR700E REAR CENTER SPEAKER PSAB700E ACTIVE SUB WOOFER PSAW700E Turn and loosen the Insert the black wire into the black(-) Turn and fasten the1 speaker connector. 23 speaker connector. terminal and the red wire into the red(+) terminal. v Connecting Center/Rear Speaker Wire 1 Press the tab of the Insert the black wire into the black(-) speaker connector. 2 Caution! • Never touch speaker terminals while terminal and the red wire into the the power is on. Doing so could red(+) terminal. result in electric shock. • Make sure the polarities (+ and -) are correctly. CONNECTIONS 10 Connecting External Components DIGITAL OUT AUDIO OUT VIDEO OUT S-VIDEO OUT R L AUDIO IN AUDIO OUT VIDEO OUT IN S-VIDEO OUT IN R L R L S-VIDEO IN DVD Player Video Player Video Projector • Disconnect the power plug from the outlet if you do not use this unit for long period of time. Before moving or installing the product, be sure to turn off the power and disconnect the power cord. Connecting Video Component 11 Caution! VIDEO IN S-VIDEO IN DIGITAL OUT AUDIO OUT VIDEO OUT S-VIDEO OUT R L DIGITAL IN SAT Player MD Player TV • If the Audio Output connector of external component is only 1, connect Audio Output connector or external component to either of Audio Input connector (right or left) of main unit. • Connect the red cable of audio cable to red connector and white cable to white connector. • When you connect Video Input connector of external component to Video Output connector of main unit, connect Video Input connector of external component either to Video Output connector or S-Video Output connector. 12 CONNECTIONS Connecting External Component R L DIGITAL OUT AUDIO OUT FRONT SU...
Эта инструкция также подходит к моделям:Ресиверы и усилители - HT-KS700 (5.9 mb)