Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
(305 mm) long 18 in. (457 mm) long 24 in. (610 mm) long Fits all Graco high pressure spray guns. (Adapters available for other guns) Includes DripLess™ Tip Guard. Order spray tip separately. GUN NOT INCLUDED WARNING Pressure Relief Procedure To reduce the risk of serious bodily injury, including fluid injection, splashing fluid or solvent in the eyes or on the skin, or injury from moving parts or electric shock, follow this procedure whenever you shut off the sprayer, when checking or servicing any part of the spray system, when installing, cleaning or changing spray tips, and whenever you stop spraying. 1. Engage the gun safety latch. 2. Shut off the pump and unplug it (or disconnect the spark plug). 3. Disengage the gun safety latch. Hold metal spray extension firmly to the side of a grounded metal pail, and trigger the gun to relieve pressure. 4. Engage the gun safety latch. 5. Open the sprayer’s pressure drain valve, having a container ready to catch the drainage. Leave the valve open until you are ready to spray again. If you suspect that the spray tip or hose is completely clogged, or that pressure has not been fully relieved after following the steps above, VERY SLOWLY loosen the tip retainer nut or hose end coupling to relieve pressure gradually, then loosen completely. Now clear the tip or hose. -WARNING- Hazard of Using Fluids Containing Halogenated Hydrocarbons Never use 1,1, 1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents in this equipment. Such use could result in a serious chemical reaction, with the possibility of explosion, which could cause death, serious bodily injury and/or substantial property damage. Consult your fluid suppliers to ensure that the fluids being used are compatible with aluminum and zinc parts. GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441 ©COPYRIGHT 1990, GRACO INC. INSTALLATION PARTS LIST Follow the Pressure Relief Procedure on the first page. See the drawing below for assembling the extension. Before installing the spray tip, start and prime the sprayer. Install the tip in the tip guard and be sure to install the tip gasket. Screw the tip guard firmly onto the adapter. NOTE: A Reverse-A-Clean IV™ DripLess™ Tip Guard may be used in place of the one supplied with the extension. Flushing Follow the flushing guidelines given in your seperate pump instruction manual. Be sure to relieve fluid pressure, and then remove the spray tip before flushing. This reduces the risk of static sparking and splashing fluid in the eyes. TIP NOT INCLUDED 12 in. (305 mm) long 18 in. (457 mm) long 24 in. (610 mm) long Model 223-390 Model 223-391 Model 223-392 REF NO. PART NO. DESCRIPTION QTY 1 180-137 NUT, gun 1 2 180-136 ADAPTER, tip 1 3 166-969 WASHER, tip 2 4 220-222 TIP GUARD 1 5 EXTENSION TUBE 218-244 12 in. for Model 223-390 1 218-245 18 in. for Model 223-391 1 218-246 24 in. for Model 223-392 1 GUN NOT INCLUDED ACC...
Эта инструкция также подходит к моделям:Распылители краски - 223391 (35.24 kb)
Распылители краски - 223392 (35.24 kb)