Оценок - 3, средний балл: 4.3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Note: LIf the batteries are fully charged, but the operating time seems to be shorter, clean the battery ends (S, T) and the charge contacts with a dry cloth. For assistance, please visit Attention: A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY (1800- 822-8837) for information on how to recycle this battery. Registering a handset to a base unit 1 Base unit: KX-TG6311/KX-TG9361/KX-TH1211 Press and hold {LOCATOR} for 4 seconds. (No registration tone) KX-TG6321/KX-TG9331/KX-TG9341/KX-TG9371 Press and hold {LOCATOR} for 4 seconds until the registration tone sounds. LIf all registered handsets start ringing, press the same button to stop. Then repeat this step. LThe next step should be completed within 90 seconds. 2 Handset: Press {OK}, then wait until a long beep sounds. Note: LWhile registering, “Base registering” is displayed on all registered handsets. LIf “Error!!” is displayed while registering, press {OFF} and register the handset again. Display language 1 {MENU} i {#}{1}{1}{0} 2 {V}/{^}: Select the desired setting. 3 Press the right soft key to save. i {OFF} For assistance, please visit Wall mounting 1 Drive the screws (not included) into the wall. 2 Mount the charger (A), then slide it down (B) and to the right (C) until it is secure. 25.4 mm (1 inch) Screws (120 V AC, 60 Hz) ABC Belt clip You can hang the handset on your belt or pocket using the supplied belt clip. NTo attach the belt clip NTo remove the belt clip For assistance, please visit For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Power connection LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire. LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire. LUnplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262). Installation LTo prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture. LDo not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident. CAUTION Installation and relocation LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily accessible. For assistance, please visit Battery LWe recommend using the supplied batteries or additional/replacement batteries noted in the base unit’s operating instructions for replacement battery information. USE ONLY rechargeable Ni-MH batteries AAA (R03) size. LDo not mix old and new batteries. LDo not open or mutilate the batteries. Released electrolyte from the batteries is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed. LExercise care when handling the batteries. Do not allow conductive materials such as rings, bracelets or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns. LCharge the batteries provided with or identified for use with this product only, in accordance with the instructions and limitations specified in this manual. LOnly use a compatible base unit (or charger) to charge the batteries. Do not tamper with the base unit (or charger). Failure to follow these instructions may cause the batteries to swell or explode. Other information LOperating the product near electrical appliances may cause interference. Move away from the electrical appliances. LUse only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions. Routine care LWipe the outer surface of the product with a soft moist cloth. LDo not use benzine, thinner, or any abrasive powder. For assistance, please visit Notice for product disposal, transfer, or return LThis product can store your private/confidential information. To protect your privacy/confidentiality, we recommend that you erase the information such as phonebook or caller list entries from the memory before you dispose of, transfer, or return the product. FCC and other information This equipment is hearing aid compatible as defined by...