Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Controls (see 1) 12 – switches the system on or to standby mode. 2Display – shows clock/alarm time and status of the set. 3TIMER – activates/deactivates the timer. FM/MW – selects the waveband: FM or MW. SET TIMER – sets the timer. 4LIGHT – adjusts the brightness of the display. 5TUNING – tunes to radio stations. 6VOL F – adjusts the sound level. 7Battery compartment 8; – 3.5 mm stereo headphone socket. 9SET TIME – sets the clock time. HOUR – adjusts the hour for the clock/alarm time. MIN – adjusts the minutes for the clock/alarm time. 0Telescopic antenna – improves FM reception. POWER SUPPLY Batteries (not included) Open the batter y door and inser t two alkaline batteries, type AA, R06 or UM3, as indicated in the batter y compar tment. • Incorrect use of batteries can cause electrolyte leakage and will corrode the compar tment or cause the batteries to burst. • Do not mix batter y types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. • When inser ting new batteries, do not tr y to mix old batteries with the new ones. • Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. This set complies with the radio interference requirements of the European Union. General information Antennas • For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. • For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. Connecting headphones • You can connect headphones to the headphone socket. . The loudspeakers will then be switched off. RADIO RECEPTION 1 Press 2 to switch on the radio. 2 Press FM/MW to select your desired waveband. 3 Select your station using the TUNING control. 4 Adjust the sound with the VOL F control. 5 To switch off the radio, press 2. Setting the clock/timer 1 In standby mode, hold down SET TIME / SET TIMER. 2 Press HOUR or MIN repeatedly, or hold down HOUR or MIN to adjust minute and/or hour. 3 Release SET TIME / SET TIMER and HOUR or MIN when you reach the correct setting. . The set clock time will show on the display and star t to run. Activating/deactivating the timer • Press TIMER once or more to activate/deactivate the timer. . The radio will automatically switch on at the set time after the timer is activated. Adjusting the brightness of the display • To change the brightness of the display, press LIGHT. SAFETY & MAINTENANCE • Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • The apparatus shall not be exposed to dripping or splashing. • To clean the set, use a dr y cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. • Batter y shall not be exposed to excessive heat such as sunshine, fire or the like. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Problem – Possible cause • Remedy No sound /power – Volume not adjusted • Adjust the VOLUME. – Batteries dead/ incorrectly inserted • Inser t (fresh) batteries correctly – Headphones connected to the set • Disconnect headphones. Poor radio reception – Weak radio signal • For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. • For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. Hearing Safety Listen at a moderate volume. • Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. • Sound can be deceiving. Over time your hearing "comfor t level" adapts to higher volumes of sound. So after prolonged listening, what sounds "normal" can actually be loud and harmful to your hearing. To guard against this, set your volume to a safe level before your hearing adapts and leave it there. To establish a safe volume level: • Set your volume control at a low setting. • Slowly increase the sound until you can hear it comfor tably and clearly, without distor tion. Listen for reasonable periods of time: • Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss. • Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. • Listen at reason...