Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
• Connect the brown wire to the terminal marked L or coloured red. • Do not connect either wire to the ear th terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make cer tain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972. English Controls/Power Supply Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at Supplied Accessories –1 x AC/DC cer tified switching adapter (Model No.: ED4120090060A, Input: 230V~ 50Hz, 70mA, Output: 9V, 600mA) – Audio cable Top & front panels (see 1) 1 FM/MW selector – selects FM/MW mode 2 Source selector – selects TUNER or AUX mode – switches off the set 3 Indicator light – indicates whether the set is on or off 4 DBB – switches DBB sound effect on or off 5 VOLUME +/– – adjusts volume level 6 Tuning wheel – tunes to an FM or MW station Back panel (see 1) 7 Telescopic antenna – improves FM reception 8 p – 3.5 mm stereo headphone socket 9 DC jack – inlet for power cord 0 AUX IN – inlet for external sound source CAUTION High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any user-serviceable parts. Modification of the product could result in hazardous radiation of EMC or other unsafe operation. This set complies with the radio interference requirements of the European Union. Power Supply Whenever convenient, use the mains supply cord if you want to conser ve batter y life. Make sure you remove the plug from the set and wall outlet before inser ting batteries. Batteries (not included) 1 Open the battery door and inser t 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "–" symbols inside the compar tment (See 1). 2 Replace the batter y door, making sure the batteries are firmly and correctly in place. The set is now ready to operate. • Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: • Do not mix batter y types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. • When inserting new batteries, do not tr y to mix old batteries with the new ones. • Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. Power Supply General Information Using AC power 1 Check if the power voltage, as shown on the type plate located on the rear of the set, corresponds to your local power supply. If it does not, consult your dealer or ser vice center. 2 Connect the supplied switching adapter to the wall socket and the DC jack on the set. The set is now ready to use. 3 To switch the set off completely, withdraw the power cord from the wall socket. • Install the unit near the AC outlet and where the power plug can be easily reached. • Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. •AC power cord is used as the disconnect device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the power cord of the apparatus shall be disconnected from the mains socket outlet completely. The type plate is located on the rear of the set. General information Antennas • For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. • For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. Connecting earphones •You can connect headphones to the headphone socket. . The loudspeakers will then be switched off. DBB sound effect You can enhance bass by enabling DBB sound effect. •To enable or disable DBB sound effect, press DBB button repeatedly. Environmental information All unnecessary packaging material has been omitted.The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment. Basic Operation Radio/AUX Basic operation Switching on radio 1 Connect the supplied switching adapter to 1 Turn the source selector to TUNER. the wall outlet and the DC jack on the set 2 Turn FM/MW selector to FM or MW to or inser t batteries as described in Power select FM or MW waveband. • Supply. Turn the source selector to TUNER to Manual tuning select tuner mode. By using this feature, it is possible to manually • Turn the source selector to AUX to select tune to a specific channel frequency. In addi- AUX mo...