SNOOZE Press the SNOOZE button to delay the alarm for six minutes after the alarm sounds. 21 CLK SET Press the CLK SET button to adjust the clock. 22 MUSIC/BUZZER Slide the MUSIC/BUZZER toggle switch to the alarm sound wake to auto (radio / CD ) or buzzer mode. 23 PHONES Use the PHONE jack to connect head-phone or ear-phone. 24 AUX IN Use the AUX-IN jack to connect other audio device to the unit. FM Antenna The FM Wire Antenna provides flexibility and range when adjusting the FM reception. An AM Antenna is built into the player. 26 AC Cord (120V/60 Hz) The attached AC (Alternating Current) cord provides power to the player. 27 Battery Back-Up (9V battery) The Battery Back-Up will save the clock and alarm settings in case of power outage. The display will not be active without AC power (batteries not included). Installation AC Plug AC Outlet CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. Unravel the AC cord and connect it to a conveniently located AC outlet having 120V and 60Hz only. The Clock Display will illuminate and "12:00" will appear in the window. BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the battery as indicated in the battery compartment. Reversed battery may cause damage to the device. 3. If the device is not to be used for a long period of time, remove the battery to preventdamage or injury from possible battery leakage. 4. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's directions) Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting itagain 2 or 3 minutes later. The preset times should continueoperating. If the present time does not appear, it indicates the battery is dead or not connected properly. The 9 volt battery will keep the internal times accurately for approximately 30 minutes. If the power is restored after 30 minutes, the times may need to be reset. NOTE: If the AC plug does not fit into a non polarized outlet, do not file or cut the wide blade. If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, remove the battery compartment cover by pressing in on the tab, connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended), then replace battery compartment cover. Operations TO SET OR RESET THE ACTUAL TIME 1. Press the CLK SET button once; the hour will blink. 2. Press the SKIP/FWD button or SKIP/REV to set the present hour . 3. Press the CLK SET button again; the minutes will blink. 4. Press the SKIP/FWD button or SKIP/REV to set the present minute. 5. Press the CLK SET button to confirm the time. TO SET OR RESET THE ALARM TIME 1. Press the desired ALARM SET button (AL1 or AL2). ; the hour will blink. 2. Press the SKIP/FWD button or SKIP/REV to set the present hour . 3. Press the ALARM SET button again; the minutes will blink. 4. Press the SKIP/FWD button or SKIP/REV to set the present minute. 5. Press the ALARM SET button to confirm the alarm time. TO SET THE ALARM TO WAKE TO CD 1. Set the alarm time as previously instructed. 2. Slide the RADIO/CD switch to the CD position and slide the ALARM switch to AUTO 3. Insert a CD and make sure the VOLUME is set as desired. 4. After alarm set step ”5” and the CD track will be shown in display. 5. Press the SKIP/FWD or SKIP/REV buttons to select CD track for alarm CD wake up and press ALARM SET button to confirm all setting. 6. When the actual time matches the selected preset alarm time(s), the unitautomatically turns on. Operations TO SET THE ALARM TO WAKE TO BUZZER 1. Set the alarm time as previously instructed. Slide the MUSIC/BUZZERswitch to BUZZER position. 2. After switch to the BUZZER position and make sure the power is off. Whenthe actual time matches the selected preset alarm time(s), the unitautomatically turns on. TO SHUT THE ALARM OFF 1. To shut the alarm off, press the POWER button once and the alarm time will be reset for the next day. 2. Press ALARM SET button (AL1 or AL2) to turn off the alarm and not set it for the next day. SNOOZE 1. The alarm can be temporarily turned off manually by pressing the SNOOZE button. 2. The alarm will turn back on automatically 6 minutes later. It can be repeated endlessly. TO ACTIVATE THE SLEEP FUNCTION 1. Press the SLEEP button and "90" will appear on the clock display. 2. "90" will appear and set the unit to turn off after 90 minutes. Press again and it will deduct 10 minutes and so on. 3. Release the SLEEP button the Sleep function will activate and the SLEEPindicator will light solid. 4. Pressing the SLEEP button until normal clock or C...