Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
2. SNOOZE/SLEEP OFF/RADIO OFF Button. 3. RADIO ON Button. 4. ALARM Button. 5. MINUTE Button. 6. CLOCK Button. 7. HOUR Button. 8. SLEEP Button. 9. DIMMER (Hi/Lo) Switch. 10. ALARM(OFF/RAD/BUZ) Switch. 11. VOLUME Control. 12. Clock Display. 13. AM/FM Band Switch. 14. Dial Scale and Pointer. 15. TUNING Control. SURE-ALARM BATTERY BACK UP SYSTEM This clock radio includes abattery back upsystem thatwill maintain thecorrect time andalarm settings in case of a temporary power interruption. Aslongas the battery has sufficient power, it will also operate the Radio or Buzzer alarm to wake you up even if the power is ‘Off’ at your normal wake up time. Thebattery back up system requires one 9 volt battery,(not included). We recommend you use an alkaline battery for longest life. • Open the battery compartment door, located on the back of the radio cabinet. • Gently pull thebattery terminaloutside the battery compartment. • Connect the 9 volt battery to the battery terminal. It can only be connected one way. • Push the battery and the terminal back into the battery compartment. • Replace the battery compartment door. If the power is interrupted the clock display goes ‘Off ’. However the clock will continue to run, powered by the 9 voltbattery. Whenpower is restored the clock will come ‘On ’ again to the correct time. The alarm setting will also be maintained. NOTE: If no battery is installed, or if the battery is exhausted and power is interrupted,thetimeandalarm settingswill belost.When power isrestoredtheclock display will begin flashing “12:00 AM”. This is your indication that the time is incorrectand needs tobe reset. Don’t forget to reset both the time and the wake up time. A fresh alkaline battery should be able to provide back up power for up to a year in normal circumstances. However if you live in an area that has frequent power interruptionsthebattery lifewill be reduced.For best resultsyoushouldinstall anew batteryevery8 to 12 months.If youinstalled abattery but younoticethat thedisplay is flashing, your battery is exhausted and should be replaced. POWER SOURCE This radio operates on 120V, 60Hz AC house current only. Unwind the AC power cord and connect the plug to any conveniently located AC outlet. NOTES: 1.) This radiouses a polarized AC plug which has one blade wider thanthe other. This plug will only fit into a polarized AC outlet. This is a safety feature. If the plug will not fit, you may have an older non-polarized AC outlet. Do not defeat thesafety featureby tryingtofile thewider blade, or replacing the plug. Contact an electrician to replace your outdated outlet. 2.) Do not connect thisunit to an ACoutlet which iscontrolled by awall switch.The AC outlet should be ‘live’at all times. ANTENNAINFORMATION FM The FM antenna is built into the AC power cord. Be sure the AC power cord is fully unwound and extended to its full length for best FM reception. AM -TheAM ferrite bar antennais inside the radiocabinet. If AM receptionis noisy or weak, try turning the radio slightly until the bar antenna is pointing towards the transmitter. Experiment until you find the position which provides the clearestreception. SETTING THE TIME • Press and hold the CLOCK and HOUR buttons to advance the display to the correcthour. • Press and hold the CLOCK and MINUTE buttons to advance the display to the correctminute. NOTE: If the AM Indicator in the upper left corner of the display is ‘On’, the time displayed is “AM”. If the AM Indicator does not appear in the display, the time displayed is “PM”. Be sure to set the time correctly for AM or PM. LISTENING TO THE RADIO • Press the RADIO ON button. • Slide the BAND selector to the desired position -AM or FM. • Select the desired station with the TUNING control. • Adjust the VOLUME control to the desired level. • Press the SNOOZE/SLEEP OFF/RADIO OFF button to shut the radio ‘Off’. SETTING THE WAKE-UP TIME • Press and hold the ALARM and HOUR buttonsto set the desired wake-up hour. • Press and hold the ALARM and MINUTE buttons to set the desired wake-up minute. NOTE: If the AM Indicator in the upper leftcorner of the display is ‘On’, the wakeuptimedisplayedis“ AM”.IftheAM Indicatordoesnotappear inthedisplay, the wake-up time displayed is “PM”. Be sure to set the wake-up time correctly for AM or PM. WAKE TO RADIO Set the wake-uptimeasindicatedabove.Alsotunetheradiotothebandand station that you want to hear at the wake up time, adjust the volume if necessary, and shut theradio‘Off’. • Slide the ALARM selector to the RAD (Radio) position. • At the selected wake-up time the radio will begin to play. It will continue for 1 hour and 59 minutes and then shut off automatically and reset itself for the followingday. • To stop the radio sooner, press the ALARM RESET button. The radio stops immediately and resets itself for the following day. • To cancel the wake to radio function slide the ALARM selector to the ‘Off’ position. WAKE TO BUZZER ALARM Set the wake up time as indicated above. • Sl...