Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
It is not possible to “overcharge” the battery cells with the charger provided. THIS PRODUCT IS FOR DRY PICK-UP ONLY. OPERATION SWITCH (FIG. D) To start, slide the On/Off switch forward (i.e. “O”= Off, “I” = On). To stop, slide the switch back. Always return the product to the charging base immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged on the charging base. CLEANING THE PRODUCT (FIGS . E-I) WARNING: Never use the Dustbuster without its filters. NOTE: The filters are re-usable, do not confuse them with disposable dust bags, and do not throw them away when the product is emptied. We recommend that you replace the filters every 6-9 months depending on frequency of use. (Use Cat. No. VF100 filters) FIG. E • Remove the dust bowl by pressing the dust bowl release button and pulling the bowl down and out. To replace the bowl, place it back onto the handle and click firmly into position. Important: For best vacuum results, empty bowl after every use. FIG. F • Empty the debris from the bowl and wash if necessary (see Fig. H). FIG. G • To remove the filters twist the outer (plastic) filter in a clockwise direction. Shake or lightly brush any loose dust off the outer filter. Remove the inner filter and shake, tap or lightly brush outside surface to remove loose dust. Both filters can be rinsed as shown in fig. (H). WARNING: Filter must be dry before re-assembling. Ensure both filters are in place before operating. FIG. G1• If your unit is equipped with a filter cleaning wheel as shown in Fig. G1 you can achieve more use between filter cleanings by first switching off the vac, and then rotating the cleaning wheel up or down as shown. Make two full rotations of wheel for best results. FIG. H • Wash the filters using warm, soapy water and ensure that they are completely dry before using it again. The cleaner the filters are, the better the product will perform. It is very important that the filter is correctly in position before use. The dust bowl can also be washed in warm soapy water. Ensure that it is dry before re-attaching. WARNING: Filters must be dry before re-assembling. IMPORTANT: Maximum dust collection will only be obtained with clean filters and an empty dust bowl. If dust begins to fall back out of the product after it is switched off, this indicates that the bowl is full and requires emptying. FIG. I • The exhaust filter is removed by opening cover and pulling out filter as shown. For best results wash filter regularly with soap and water. FIG. J • Never immerse the product in water. A damp cloth and soapy water should be used to clean the exterior of the motor section. Always ensure the product is completely dry before re-use or storing. ECONOMIC USAGE • Your product is very economical to charge. While it is charging it uses less electricity than a typical night light bulb. • When fully charged and with a clean filter, the average effective usage times vary by voltage. 7.2 volts: 7 - 9 minutes 9.6-12 volts: 9-11 minutes 14.0 volts and higher: 12-15 minutes TROUBLE SHOOTING If the product does not work, check the following: • That the charge indicator light is on when unit is in base. • The charger was correctly plugged in for recharge. ( It feels slightly warm to the touch.) • The charger cord is not damaged and is correctly attached to the base. • The charger is plugged into a working electrical outlet. • That the switch is in the “OFF” position when charging. ACCESSORIES Accessories are stored on the product (FIG. K) and are fitted into the nose of the product for use. Accessory use is shown in FIG. L. Note: Replacement filters can be purchased from most local/national retailers that sell vacuums. Look for VF100 filters. BATTERY REMOVAL AND DISPOSAL This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries. When the batteries no longer hold a charge, they should be removed from the Vac and recycled. They must not be incinerated or composted. The batteries can be taken for disposal to a Black & Decker, Company-Owned or Authorized Service Center. Some local retailers are also participating in a national recycling program (see “RBRCTM Seal”). Call your local retailer for details. If you bring the batteries to a Black & Decker Company-Owned or Authorized Service Center, the Center will arrange to recycle old batteries. Or, contact your local municipality for proper disposal instructions in your city/town. To remove the battery pack for disposal: 1. Remove accessories from the bottom of the unit. 2. Using a Phillips screwdriver remove the screws as shown in Fig "M". Then use the screwdriver to push the lock tabs in the direction shown. 3. Pull the battery cover off as shown in Fig. N. 4. Using a Phillips screwdriver remove the two battery location screws as shown in Fig "O". After removing the screws push the battery pack back as shown. 5. Remove the battery pack (Fig. P) and dispose as stated above. To replace ...