Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. MEDICAL NOTE: The liquid is a 25-35% solution of potassium hydroxide. IMPORTANT CHARGING SAFETY INSTRUCTIONS CHARGING PROCEDURE THE BATTERY PACK IS NOT FULLY CHARGED AT THE FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS BEFORE USE. The charger is designed to use standard household 120 volt 60 Hz power. 1. Plug the charger into any standard 120 Volt 60 Hz electrical outlet (figure 1). 2. Slide the charger onto the battery pack as shown in figure 2 and let the battery pack charge initially for 9 hours. After the initial charge, under normal usage, your battery pack should be fully charged in 6 to 9 hours. 2a) During charging the green LED will appear. 2b) When charging is complete the green LED will go off. 3. Unplug charger, and remove the battery pack. Place the battery pack into the tool until it “clicks” into place. NOTE: To remove the battery pack, press down on the release button on the back of the battery pack and slide out (figure 3). IMPORTANT CHARGING NOTES 1. After normal usage, your battery pack should be fully charged in 6 to 9 hours. If the battery pack is run-down completely, it may take up to 9 hours to become fully charged. Your battery pack was sent from the factory in an uncharged condition. Before attempting to use it, it must be charged for at least 9 hours. 2. DO NOT charge the battery pack in an air temperature below +40°F(+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack. Longest life and best performance can be obtained if battery pack is charged when air temperature is about 75°F (24°C). 3. While charging, the charger may hum and become warm to touch. This is a normal condition and does not indicate a problem. 4. If the battery pack does not charge properly—(1) Check current at receptacle by plugging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights. (3) Move charger and battery pack to a surrounding air temperature of 40°F (+4.5°C) to 105°F (+40.5°C). (4) If the receptacle and temperature are OK, and you do not get proper charging, take or send the battery pack and charger to your local Black & Decker service center. See Tools Electric in yellow pages. 5. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE using unit with its battery pack in a depleted condition. 6. The battery pack will reach optimum performance after being cycled 5 times during normal usage. There is no need to run the battery pack down completely before recharging. Normal usage is the best method of discharging and recharging the battery pack. STORAGE RECOMMENDATION 1. Store tool: a.) with the battery pack removed and on the charger. b.) in a place that is cool and dry away from direct sunlight and excess heat or cold. c.) out of the reach of children. 2. For prolonged storage such as over the winter, the battery pack should be fully charged and then removed from the charger. It should be charged again just prior to use. LEAVING THE BATTERY PACK IN THE CHARGER It is OK to leave battery packs on charge for long periods of time. The charger has amaintenance mode which gives the battery pack enough charge to stay “topped off”. Ifhowever, the tool is not expected to be needed for more than 30 days, unplug the charger andstore battery pack in a cool, dry location. NOTE: A battery pack will lose its charge when keptoff of the charger. If the battery pack has not been kept on maintenance charge, it may needto be recharged before use. A battery pack may also lose its charge if left in a charger that isnot plugged into an appropriate AC source. SWITCH The switch can be operated by moving the lever from side to side. The “ON” and “OFF” positions are marked on the housing as shown in Figure 4A & 4B. CAUTION: DO NOT POINT UNIT DISCHARGE AT SELF OR BYSTANDERS. OPERATION CAUTION: Always wear safety glasses. Wear a filter mask if the operation is dusty. Use of gloves, long pants and substantial footwear is recommended. Keep long hair and loose clothing away from openings and moving parts. THIS SWEEPER IS FOR HOUSEHOLD USE ONLY. NOTE: Ensure the blower is switched off and the battery is removed before attaching or removing the sweeper tubes. • TUBE ASSEMBLY: To attach the inner tube to the sweeper, line up the tube with the sweeper housing as shown in figure 5. Push the tube into the sweeper housing until the lock button engages the lock hole in the tube. Repeat this process for the outer tube. • Hold the sweeper with one hand as shown in figure 6 and sweep from side to side with the nozzle several inches above the ground. Slowly advance keeping the accumulated pile of debris in front of you. Maintenance CLEANING AND STORAGE CAUTION: DO NOT POUR OR SPRAY WATER...
Эта инструкция также подходит к моделям:Пылесосы - CARDLESS BROOM NS118 (513.62 kb)