Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
A beep sounds and the learned button name and “OK” appear in the third line on the screen. 7 To programme signals on other buttons, repeat steps 5 and 6. 8 Press the (light) button. The display returns to the screen shown in step 3. 9 Press the (light) button or the RETURN button twice. The set mode closes, and the Remote Commander returns to standby for operating the A/V components. 12GB Notes • If you do not input anything into the Remote Commander within 60 seconds between each step, the setup procedure will be cancelled and the set mode closes. Start over from the beginning. • If you do not perform step 6 within 10 seconds after performing step 5, a beep sounds twice and the selected button name and “NG” appear in the third line on the screen, then the display returns to the screen shown in step 4. Start over from step 5. • If the Remote Commander learns signals incorrectly in step 6, clear the learned signal by pressing the (light) button while pressing the button on which the incorrect signal was learned (page 14). Start over from step 5. • If you programme remote signals on the TV or amplifier’s volume control buttons using the Learning function (page 12), those buttons will also send the learned signal to control components other than a TV or amplifier. If you programme remote signals on the volume control buttons of components other than a TV or amplifier, those buttons will also send the learned signal to control other A/V components instead of controlling the TV or amplifier’s volume. •To avoid misoperation, the Remote Commander will only transmit z/REC (record) button signals if the button is pressed and held for over 2 seconds. Therefore, if this button is used for a learned operation, you must press and hold it for over 2 seconds. Programming a signal on the COMPONENT select button 1 Perform steps 1-3 of the learning procedure (page 12). 2 Press and hold the COMPONENT select button or Label select button on which you want to programme the signal. The display turns off and the Remote Commander enters into the Learning mode. 3 Press and hold the button on the other remote control until you hear a beep. A beep sounds and the learned button name and “OK” appear in the third line on the screen. 4 To programme signals on other COMPONENT select buttons or Label select button, repeat steps 2 and 3. 5 Press the (light) button. “LEARN” appears as the screen title. 6 Press the (light) button or the RETURN button twice. The set mode closes, and the Remote Commander returns to standby for operating the A/V components. Continued 13GB If the Remote Commander does not seem to be working properly Changing or clearing the function of a “learned” signal If the Remote Commander does not seem to be working properly Changing or clearing the function of a “learned” signal If the learned button does not operate properly, clear the learned signal first (page 14), then perform the learning proced...